- New
Product description: Multi-GNSS positioning module - LC76G - GPS, BeiDou (BDS), GLONASS, Galileo, QZSS - Waveshare 24370
The LC76G module from Waveshare is an advanced GNSS navigation board , supporting GPS, BeiDou, GLONASS, Galileo and QZSS systems. It is capable of simultaneous positioning using multiple systems or independent positioning within one system. This module supports EPO and EASY technologies , which enable faster, more accurate and more efficient positioning. It communicates via UART and I2C interfaces, so it can be connected, for example, to Raspberry Pi or Arduino . It also has a built-in low-noise LNA amplifier that increases the sensitivity of signal reception and supports the 1PPS time synchronization function . An active ceramic antenna is connected to the module.
The product is compatible with Raspberry Pi, Arduino and ESP32.
Also check the guide prepared by the manufacturer.
Multi-GNSS positioning module - LC76G - GPS, BeiDou (BDS), GLONASS, Galileo, QZSS - Waveshare 24370.
The board supports multiple location systems, including GPS, BeiDou, Galileo, GLONASS and QZSS.
Special features of the module
- Supports Multi-GNSS systems: GPS, BeiDou, Galileo, GLONASS and QZSS
- Supports EPO (Extended Predictive Orbit) and EASY (Embedded Assist System) technologies
- It communicates via UART and I2C interfaces
- It is equipped with a low-noise LNA amplifier for better signal reception
- Uses the 1PPS (Pulse Per Second) time synchronization function
- Includes LED indicators informing about the module's operating status
- Works with boards such as Raspberry Pi, ESP32 or Arduino
EPO and EASY technology
The module uses EPO (Extended Predictive Orbit) and EASY (Embedded Assist System) technologies for quick positioning. EPO enables orbit prediction of GNSS satellites up to 30 days , which shortens the first launch time by using stored orbital data, even in difficult signal reception conditions. EASY, on the other hand, stores satellite ephemeris data in the module's memory , which allows you to run positioning without the need to download this data from external sources each time. These technologies allow for faster positioning and increase accuracy after turning on the module.
Set contents
- Multi-GNSS positioning module - LC76G - GPS, BeiDou (BDS), GLONASS, QZSS
- MX1.15 cable with 8-pin connector
The set includes an MX1.15 cable with an 8-pin connector.
Technical specifications of the module
- Model: LC76G
- Built-in navigation chip: AG3352
- Supported satellite systems: GPS / GLONASS / Galileo / BDS / QZSS
- L1 lane receiver: 47 tracking channels
- SBAS support: yes
- A-GNSS support: yes
- Sensitivity:
- Acquisition: -147 dBm
- Re-acquisition: -159 dBm
- Tracking: -166 dBm
- Time-To-First-Fix
- Cold starts: autonomous up to 26 s, EASY up to 12 s and EPO up to 5 s
- Wars starts: autonomous up to 2 s (with EASY)
- Hot starts: up to 1 s
- Position accuracy: 1.5 m CEP
- Speed accuracy: 0.1 m/s
- Acceleration accuracy: 0.1 m/s²
- Timing accuracy: 30 ns
- I2C transmission rate: max. 400 kbps
- UART baud rate:
- Range: from 9600 bps to 921600 bps
- Default: 115200 bps
- GNSS data update speed:
- Maximum: 10 Hz
- Default: 1 Hz
- Additional features: Geo-Fence, interference detection, anti-jamming, LNA
- Module dimensions: 30.5 x 25.5 mm
Useful links |
