List of products by brand SparkFun - Strona 6
RFID reader ID-3LA - 125kHz - SparkFun SEN-11862
Easy to use reader that allows you to receive and transmit through the serial interface to the main device (e.g. Arduino) ID of RFID, for example: pill, capsule or card. The...- Sale
- SPECIAL OFFERS
SD card reader module - SparkFun BOB-12941
Module of the SD MMC memory card reader from the SparkFun. It provides communication with the main board (e.g. Arduino or STM32Discovery).- Reduced price
- SPECIAL OFFERS
Converter USB-UART FTDI 3,3V miniUSB - SparkFun DEV-09873
Small converter enables the connection between serial interfaces USB and UART. It allows to exchange data between the computer and the systems which use microcontrollers. The...- Sale
- SPECIAL OFFERS
Big Push Button 10cm red - SparkFun COM-09181
Big button with an outer diameter of 10 cm, with built-in LED illuminating the dome.Antenna GPS Embedded with SMA connector - SparkFun GPS-00177
GPS antenna, designed for small mobile projects. It is supplied with the voltage of 3.3 V, it has a gain of 26 dB, it is equipped with a standard SMA connector with a cable...RedBot - line sensor (line follower) - SparkFun SEN-11769
Addition to the RedBot Kit extending the robot with the ability to detect the line. The sensor detects light reflected from the surface and on its basis determines the color of...Arcade Concave Button 3,5cm - yellow - SparkFun COM-09338
Concave button with an outer diameter equal to 35 mm and a height of 65 mm. To the button attached is a simple limit switch.Arcade Concave Button 3.5cm - black - SparkFun COM-09339
Dished button with an outer diameter equal to 35 mm and a height of 65 mm. To the button attached is a simple limit switch.- Sale
- SPECIAL OFFERS
Arcade Concave Button 3.5cm - blue - SparkFun COM-09337
Concave button with an outer diameter equal to 35 mm and a height of 65 mm. To the button attached is a simple limit switch.- Sale
- SPECIAL OFFERS
Qwiic JST Connector - SMD 4-pin - SparkFun PRT-14417
JST 4-pin SMD connector for Qwiic boards using the I2C interface. Pins pitch is 1 mm.Qwiic HAT for Raspberry Pi - SparkFun DEV-14459
Shield, type HAT for Raspberry Pi, facilitating the connection of modules SparkFun via connectors Qwiic. The shield connects the I2C bus on the Raspberry Pi with connectors Qwic.MicroSD card reader module - SparkFun BOB-00544
Reader of microSD memory cards from the SparkFun. It communicates with main Board via SPI interface, it operates with a voltage of 3.3 V.GPS ZOE-M8Q module - Qwiic - SparkFun GPS-15193
ZOE-M8Q is a highly accurate, miniature tile with a 72 channel GNSS receiver capable of receiving signals from GPS, GLONASS, BeiDou and Galileo. It communicates via SPI / I2C...Converter USB-UART FTDI 5V miniUSB - SparkFun DEV-09716
Small converter enables the connection between serial interfaces USB and UART. It allows to exchange data between the computer and the systems which use microcontrollers. The...Stepper Motor 39BYGL215A with threaded shaft 12V/ 0.4A/ 0.20Nm - SparkFun ROB-10848
Bipolar stepper motor, four-wire. It has a threaded shaft, which allows the device to be used as a linear actuator. It is powered by 12 V and draws 0.4 A per coil. The holding...- Sale
- SPECIAL OFFERS
XBee Explorer USB v2 module - SparkFun WRL-11812
USB converter for XBee module. It works with all XBee systems from 1 & 2.5, standard and pro series. This version has the RESET button for the XBee system.- Sale
- SPECIAL OFFERS
ADXL335 3-axis analog accelerometer - SparkFun SEN-09269
Sensor for measuring acceleration in three axes in the range of ± 3 g. Powered with the voltage from 1.8 V to 3.6 V; it consumes only 320 uA of the current. The output signal...Deflection sensor 112x6,3mm - SparkFun SEN-08606
During the bending, sensor increases its resistance. It can be used to detect the movement of your hand. Sensor length: 112 mm.MicroView - USB programmer - SparkFun DEV-12924
USB programmer for the module of MicroView OLED display. The device is equipped with male and female connectors, thanks to this, board can be attached directly or connect using...- Sale
- SPECIAL OFFERS
Simple Servo Trigger Servo Controller - SparkFun WIG-13118
A simple controller allowing the servo to move from position A to B after changing the state on the IN input pin. The position can be adjusted with potentiometers. The system...LilyTiny microcontroller ATtiny85 - programming - SparkFun DEV-10899
Miniature module with programmed Attiny85 AVR microcontroller, it has an 8-KB of Flash memory, 4 digital pins, analog input and 2 PWM channels. Uploaded program presents...- Sale
- SPECIAL OFFERS
Servo Trigger - Continuous Rotation - SparkFun WIG-13872
Module facilitating servo operation. On receiving an external signal, the controller moves the servo from position A to position B at a predetermined speed. The supply voltage...RedBoard - Arduino compatible - SparkFun DEV-13975
SparkFun's module is fully compatible with Arduino Uno. It has 14 digital inputs/outputs, 6 PWM channels, 6 analog inputs and popular communication interfaces. On the board...- Sale
- SPECIAL OFFERS
FlexiForce Pressure Sensor - 100lbs - SparkFun SEN-08685
Pressure sensor reduces its resistance when the force put to its tip, increases. Sensor with a length of 216 mm, the maximum pressure is approx. 45 kg.- Sale
- SPECIAL OFFERS
