- New
Product description: TSMP96000 Code Learning - IR 20 - 60 kHz infrared receiver - STEMMA JST PH 2 mm - Adafruit 5970
The TSMP96000 module from Adafruit is an IR receiver designed to receive signals from remote controls with frequencies from 20 kHz to 60 kHz . This makes it universal and can receive signals from different IR remote controls, even if you do not know the exact frequency of the signal. The module is powered by a voltage of 3 V to 5 V , and the output signal is sent to a microcontroller, which then decodes the received signal. There are LEDs on the board - green indicates power, and red informs about the reception of an IR signal. The module is easy to use thanks to the STEMMA JST PH connector with a 2 mm pitch , which allows connection without the need for soldering . Ideal for projects related to receiving IR signals, especially in "Code Learning" applications, where the device must work with different remote controls.
Arduino compatible product!
The manufacturer has prepared a detailed user guide - check it out!
TSMP96000 Code Learning - IR infrared receiver 20 - 60 kHz - STEMMA JST PH 2 mm - Adafruit 5970.
The receiver detects infrared signals in the range of 20 kHz to 60 kHz.Main features of the receiver
- Wide IR frequency range compatibility: receives infrared signals from 20 kHz to 60 kHz, allowing it to work with a wide range of remote controls
- Power supply : the module is powered by a voltage of 3 V to 5 V, compatible with most microcontrollers
- Simple installation: no soldering required, just use STEMMA JST PH cable with a 2 mm pitch
- LEDs: green diode for correct power supply and red diode for signal reception
- No signal demodulation : the module does not provide a demodulated signal, it requires code designed specifically for "Code Learning"
Connecting the module and terminals
The module is equipped with a STEMMA JST PH connector with a 2 mm pitch , which allows easy connection. It has 3 pins:
- GND - ground
- V+ - power supply
- SIG - signal
Thanks to this solution, connecting the module to the microcontroller becomes simple and convenient, and the whole thing does not require soldering.
Diagram of connecting the module to the Metro minicomputer.
Thanks to the mounting holes, the board is easy to mount in enclosures and devices.
Technical specification of the module
- IR Frequency Range: 20 kHz to 60 kHz
- Supply voltage: 3 V to 5 V DC
- Connector: STEMMA JST PH with 2 mm pitch (3-pin)
- LEDs:
- Green LED: Indicates correct power supply
- Red LED: Indicates IR signal reception
- Dimensions: 25.4 x 17.7 x 7.1 mm
- Weight: 2.1 g
Kit Contents
- 1x TSMP96000 Code Learning - IR 20 - 60 kHz infrared receiver - STEMMA JST PH 2 mm - Adafruit 5970
