List of products by brand SparkFun - Strona 5
Qwiic HAT for Raspberry Pi - SparkFun DEV-14459
Shield, type HAT for Raspberry Pi, facilitating the connection of modules SparkFun via connectors Qwiic. The shield connects the I2C bus on the Raspberry Pi with connectors Qwic.MicroSD card reader module - SparkFun BOB-00544
Reader of microSD memory cards from the SparkFun. It communicates with main Board via SPI interface, it operates with a voltage of 3.3 V.GPS ZOE-M8Q module - Qwiic - SparkFun GPS-15193
ZOE-M8Q is a highly accurate, miniature tile with a 72 channel GNSS receiver capable of receiving signals from GPS, GLONASS, BeiDou and Galileo. It communicates via SPI / I2C...RFID reader ID-20LA - 125kHz - SparkFun SEN-11828
Easy to use reader with integrated antenna, allowing to receive and transmit through the serial interface to the main device (e.g. Arduino), the ID of the RFID identifier....Converter USB-UART FTDI 5V miniUSB - SparkFun DEV-09716
Small converter enables the connection between serial interfaces USB and UART. It allows to exchange data between the computer and the systems which use microcontrollers. The...Stepper Motor 39BYGL215A with threaded shaft 12V/ 0.4A/ 0.20Nm - SparkFun ROB-10848
Bipolar stepper motor, four-wire. It has a threaded shaft, which allows the device to be used as a linear actuator. It is powered by 12 V and draws 0.4 A per coil. The holding...- Sale
- SPECIAL OFFERS
XBee Explorer USB v2 module - SparkFun WRL-11812
USB converter for XBee module. It works with all XBee systems from 1 & 2.5, standard and pro series. This version has the RESET button for the XBee system.- Sale
- SPECIAL OFFERS
ADXL335 3-axis analog accelerometer - SparkFun SEN-09269
Sensor for measuring acceleration in three axes in the range of ± 3 g. Powered with the voltage from 1.8 V to 3.6 V; it consumes only 320 uA of the current. The output signal...- Sale
- SPECIAL OFFERS
Deflection sensor 112x6,3mm - SparkFun SEN-08606
During the bending, sensor increases its resistance. It can be used to detect the movement of your hand. Sensor length: 112 mm.MicroView - USB programmer - SparkFun DEV-12924
USB programmer for the module of MicroView OLED display. The device is equipped with male and female connectors, thanks to this, board can be attached directly or connect using...- Sale
- SPECIAL OFFERS
Simple Servo Trigger Servo Controller - SparkFun WIG-13118
A simple controller allowing the servo to move from position A to B after changing the state on the IN input pin. The position can be adjusted with potentiometers. The system...Servo Trigger - Continuous Rotation - SparkFun WIG-13872
Module facilitating servo operation. On receiving an external signal, the controller moves the servo from position A to position B at a predetermined speed. The supply voltage...RedBoard - Arduino compatible - SparkFun DEV-13975
SparkFun's module is fully compatible with Arduino Uno. It has 14 digital inputs/outputs, 6 PWM channels, 6 analog inputs and popular communication interfaces. On the board...- Sale
- SPECIAL OFFERS
FlexiForce Pressure Sensor - 100lbs - SparkFun SEN-08685
Pressure sensor reduces its resistance when the force put to its tip, increases. Sensor with a length of 216 mm, the maximum pressure is approx. 45 kg.- Sale
- SPECIAL OFFERS
FlexiForce Pressure Sensor - 25lbs. (1" area) - SparkFun SEN-11207
Pressure sensor reduces its resistance when the force put to the round tip, increases. The round sensor with a diameter of 25.4 mm, the maximum pressure is 11 kg.Piezoelectric vibration sensor - SparkFun SEN-09196
Piezoelectric vibration sensor, used for measurement of touch, vibration, shock and flexibility. A small AC voltage and high voltage up to 90 V, it occurs when the foil moves...LiPo Charger/Booster - Li-Pol charger - 5V/1A - PAM2401 - SparkFun PRT-14411
Charger for 1-cell lithium polymer batteries with a nominal voltage of 3.7 V. The supply voltage is 5 V, the maximum current is 500 mAh. The device has a 5 V 1 A booster. The...Camera PixyCam ver. 2.1 CMUcam5 - a smart image sensor - SparkFun SEN-14678
An intelligent image sensor with a built-in processor, thanks to which the robot can find objects. Pixy has support for various devices, e.g. Arduino, Raspberry Pi or...- Sale
- SPECIAL OFFERS
Qwiic Mux Breakout - 8-channel module with multiplexer I2C - TCA9548A - SparkFun BOB-16784
Module with a multiplexerem TCA9548A, allows you to connect 8 different digital I2C interfaces to one interface. Works with a supply voltage from 1.65 V to 5.5 V. The address...Qwiic Scale - NAU7802 module for tensometric beam - SparkFun SEN-15242
The module is based on a NAU7802 system enabling the reading of data from a strain-gauge beams. By connecting the model to the microcontroller, you can read the change in...WiFi module Thing Plus - ESP32 WROOM - SparkFun WRL-15663
The SparkFun module is equipped with ESP32 WROOM and ESP32-D0WDQ6 for wireless communication using WiFi and Bluetooth. Thing Plus for communication uses Qwiic Connect...Servo pHAT - 16-channel PWM I2C driver for Raspberry Pi - SparkFun DEV-15316
The Servo pHAT overlay from SparkFun allows you to control up to 16 servos via an I2C interface. The chip generates PWM signals up to 1.6 kHz with 12-bit precision ....SparkFun Qwiic Adapter - SparkFun DEV-14495
The Qwiic adapter from SparkFun provides an ideal way to convert a regular I2C bus into a board with a Qwiic connector for simple connection. The adapter has two Qwiic...Flexible Qwiic Cable with 4-pin plug - 5cm - SparkFun PRT-17259
SparkFun four core cable for Qwiic system. The cable is terminated with JST type connector, with four pins of 1 mm pitch. Its length is 5 cm . It was designed for simple...
