- EOL
|
Attention! The product has been discontinued. Check others products in category. |
Description
The module allows to control 16 devices via a PWM signal, e.g. support DC motor drivers, set the position of the servos, control brightness of directly connected LEDs. The system communicates with the main module via the SPI bus. For Arduino users it has a library and example program for convenient operation of the module.
Outputs are holes for popular goldpin connectors - raster of 2.54 mm, which allows you to connect directly to Arduino or to connect the circuit into the contact board or connect using wires. The channels were marked on the board, next to each signal output there are: supply voltage VCC and the ground GND, which facilitate the connection of servos.
|
The set does not contain a goldpin strip, it can be purchased separately. |
Specification
- Supply voltage: 3 V to 5.5 V
- Current consumption: 10 mA to 120 mA depending on load
- Performance voltage:
- 60 mA for supply of 3.3 V
- 120 mA for supply of 5 V
- Communication: SPI bus
- Resolution of the signal (PWM): 12-bit (4096 States)
