Description
Shield for Raspberry Pi witha flexible display e-paper of 2.13 "with a resolution of212 x 104 pixels. It is connected directly to GPIO pins. It communicates viaSPIinterface.It supports partial updates.Compared to standard displays of e-Paper, this flexible display isresistant to damage, islighter and thinner.
The subject of the sale is a shield with display, minicomputerRaspberry Pican be purchased separately.
The display is characterized by a very low power consumption, wide viewing angle, clear image without electricity, it is the ideal choice in the case when you need to use the screen on a curved surface.
Key features
- It does not have a backlight, it will show the latest image for a long time in the case of lacking power
- Very low current consumption, it is only necessary for updating
- Compatible with Raspberry Pi Zero / Zero W / Zero WH / 3B+ / 3B / 2B
- Reserved soldered connector for the SPI interface, for connection with other devices like Arduino / Nucleo, etc.
Insights
The device has a 9-pin connector.
Pin | Description |
---|---|
VCC | Supply voltage: 3.3 V or 5 V. |
GND | The ground of the system. |
NC | Not connected. |
DIN | Pin MOSI of SPI interface. |
CLK | Clock pin of SPI interface. |
CS | Chip select is activated by low status. |
DC |
Selection data / command. High status - data Low status - commands |
RST | External reset is activated by low status. |
BUSY | "Busy" status output, activated by the low status. |
Specification
- Working voltage: 3.3 V
- Interface: 3-pin SPI or 4-pin SPI
- External dimensions: 59,2 x 29,2 x 0.3 mm
- Display size: 48,55 mm x 23, 71 mm
- Spot size: 0,229 x 0,228
- Resolution: 212 x 104 pixels
- Displayed colors: black and white
- The gray level: 2
- Time of full update: 2 seconds
- Power consumption during update: 26,4 MW
- Power consumption at rest: < 0,017 MW
- Viewing angle: > 170 °
Set includes
- Flexible display e-Paper of 2.13"
- Shield e-Paper for Raspberry Pi
- The screws and mounting spacers
- PH 2.0 8-pin cable
Useful links |