Product description:TFT LCD 2.8'' 320x240px Adafruit touch screen display with microSD reader
2.8" TFT LCD touch screen graphic display with 320 x 240 px resolution and 18-bit colour depth. It works with both 3.3 V and 5 V. Additionally, there is a micro SD memory card reader on the board.
The screen is based on the ILI934 controller and has a built-in RAM memory, so the microcontroller is not burdened with display control. The device can communicate in two modes: 8-bit mode and via SPI bus. For 8-bit mode, eight digital data lines and four control lines must be connected. SPI requires only five transmission lines, but is slower than 8-bit communication. In addition, four additional pins are required to operate the touch screen.
The leads areholes for the includedgoldpin connector- 2.54 mm raster (for self-soldering). They allow for connection of the display through wires or plugged into the contact plate.
Thanks to the built-in voltage converter the system works with both 3.3 V and 5 V logic. The installed slot allows to provide graphic files on micro SD card with FAT16/FAT32 system.
|
Product compatible with Arduino On Adafruit website you can finda user's guidetogether with theArduino userlibrary. |
Exits
The device can work in two modes: 8-bit communication and SPI, SPI outputs are shown in the table below. Details of 8-bit connection can be found in the tutorial.An example of a touch screen connection is available inthe user guide.
| Pin | Description |
|---|---|
| VIN | Screen illumination: 3.3 V to 5 V. |
| GND | The weight of the system. |
| MISO | SPI bus input data line. |
| SCK | SPI bus clock line. |
| MOSI | SPI bus output data line. |
| CS | SPI bus device selection - chip select for display. |
| D/C | Transmission selection pin: data/command. |
| RST | Reset the system. |
2.8'' TFT LCD touch screen specification
- Supply voltage: 3.3 V to 5.0 V
- Output operating voltage: 3.3 V to 5.0 V
- 4-wire touch screen
- The driver:ILI9341
- Diagonal of the screen: 2.8 inches
- Resolution: 320 x 240 px
- Deep in color: 18-bit
- White LED backlighting with controllable brightness via PWM signal
- Communication: SPI or 8-bit mode
- Built-in slot for microSD memory card
Useful links |
