Thumb Joystick with v2 button - module with a plate - Iduino ST1079

Index: MOD-04093 EAN: 5903351241441

The module is equipped with a joystick similar to analog devices used for example in PlayStation 2 controllers. It has the possibility of detecting movement in two directions and the button is activated by pressing the handle.

Thumb Joystick with v2 button - module with a plate - Iduino ST1079
€1.90
€1.54 tax excl.
Available
Shipping in 24 hours
PayPal payment
Manufacturer: OpenPlatform

Description

A joystick similar to analog devices used for example in PlayStation 2 controllers. The detection of the direction of movement is done via two potentiometers - one (4.7 kΩ) for each axis. The device also has a button activated by pressing the handle.

          thumb-joystick-z-przyciskiem-v2-modul-z-

To use the device sufficient is microcontroller with analog-to-digital converter (analogue input in theArduino). Information about the position of the handle is transmitted via an analog signal, in which voltage corresponds to the given position. Each axis has a separate analog pin. The status of the button is detected via the digital output which, in case of activation, reaches a low status. 

Connection

Using the board to connect the joystick is reduced to the following pins:

  • VCC - supply voltage (5 V).
  • GND- ground of the system.
  • VRx - the analog output for the vertical axis (in the middle position, the value is equal to half of the supply voltage VCC/2).
  • VRy- Analog output for the horizontal axis (in the middle position, the value is equal to half of the supply voltage VCC/2).
  • SW- Digital signal button, in case of activation, it reaches the value of the GND, deactivated - is in thefloating status - so you need to add a pulling-up resistor to power.

 

Attention!

  • Because of the few-procent tolerance of the resistors, the middle value may not be equal to half the supply voltage (VCC/2). The manufacturer recommends measuring the voltage in the middle position and writing a permanent, rigid value in the program.

 

  • The joystick is a device of low power. It must be connected only to the inputs of high input impedance, for example, the ports of the microcontroller. Do not connect the device to the elements consuming a relatively large current: LEDs, motors - as this will damage the system.

 

Switch - type2 monostable
Switch - type Joystick + module
Switch - shape round
Switch - backlight no
Colour black
Length 25 mm
Width 25 mm
Height 35 mm
Package width 6 cm
Package height 7 cm
Package depth 3.5 cm
Package weight 0.011 kg

Aleksandra

02/27/23

Question: What are the dimensions of the joystick?
Answer: The joystick's dimensions are 34 x 26 x 34 mm (L x W x H).
Lis

02/28/22

Question: Does the joystick return to its zero position when you move it
Answer: The joystick returns to the zero position when released.

Product reviews

Thumb Joystick with v2 button - module with a plate - Iduino ST1079

4.9/5

Average grade

12

Customers opinion
The following opinions are collected
and verified by
an external partner Trustmate
and come from the post-purchase process.

Zdjęcia użytkowników

Customers who bought this product also bought:

Products from the same category: