- New
- On sale!
- Promotion
LED RGB - Unit expansion module for development modules M5Stack
Index: MSS-18085
- Reduced price
- Promotion
- On sale!
- Promotion
Qwiic pHAT Extension for Raspberry Pi 400 - SparkFun DEV-17512
Index: SPF-18853
- Reduced price
- Promotion
Trill Hub - Grove - expansion hub for Trill - Bela touch sensors
Index: BEL-18513
- On sale!
- Promotion
- Reduced price
- Promotion
Plastic case Kradex ZP75.75.45UJ TM ABS - 75x75x45mm - light gray
Index: KDX-23055
- Reduced price
- Promotion
SparkFun Qwiic pHAT v2.0 - hat for Raspberry Pi - SparkFun DEV-15945
Index: SPF-21165
- Reduced price
- Promotion
Grove modules - Strona 8
Loading...
Grove - module with LED RGB WS2813 diode - Seeedstudio 104020169
The module is equipped with RGB LED with WS2813 chip. It works with a voltage of 3.3 V and 5 V . The use of Grove connector makes it much easier to connect the module to...
Index: SEE-15553
Index: SEE-15553
Grove - LED String Light - LED driver
Grove series module that allows you to control the LED strip included in the kit . The supply voltage is from 3.3 V to 5 V. Since the LEDs work with 12 V, the module is...
Index: SEE-11329
Index: SEE-11329
- Reduced price
- Promotion
The original Grove ring has 24 controlled LEDs. In the middle of the ring there is a square hole measuring 1.6 cm x 1.6 cm. Compatible with Arduino, connects via a digital...
Index: SEE-14989
Index: SEE-14989
Trill Hub - Grove - expansion hub for Trill - Bela touch sensors
Handy Trill Hub extension hub for Trill touch sensors from Bela and other I2C devices. It is useful for projects using more I2C ports as it allows up to 10 different...
Index: BEL-18513
Index: BEL-18513
- On sale!
- Promotion
A module based on the Bosch BMA456 sensor, which can act as a pedometer. The BMA456 is a small 3-axis acceleration sensor. The board is equipped with a Grove connector and a...
Index: SEE-15328
Index: SEE-15328
Grove - Doppler Radar - BGT24LTR11 - 24GHz transceiver - 10m - Seeedstudio 109020021
Doppler radar based on BGT24LTR11 chip and XMC1302 controller with ARM Cortex-M0 processor. It allows for precise distance measurements and motion detection using radar...
Index: SEE-17023
Index: SEE-17023
Joystick V1.1 MEGA8A - expansion Unit for M5Stack development modules
Joystick V1.1 MEGA8A in the form of a Unit extension for use with M5Stack development modules. The controller has the form of an analog knob similar to those used, among...
Index: MSS-21398
Index: MSS-21398
- Reduced price
- Promotion
Grove Starter Kit for Seeed Xiao - Seeedstudio 110010044
Grove Starter Kit for Seeed Xiao is a set of Grove modules with an overlay designed to work with the Seeed Xiao module. The manufacturer has also prepared a series of guides...
Index: SEE-21851
Index: SEE-21851
SenseCAP S2110 Sensor Builder - Grove sensors to RS485 converter - Seeedstudio 114992986
SenseCAP S2110 Sensor Builder is an open source tool for creating RS485 sensors using Grove sensors. It also allows you to build a custom industrial-grade LoRaWAN sensor...
Index: SEE-22927
Index: SEE-22927
Grove - StarterKit v3 - IoT starter package for Arduino
Starter set introducing the world of IoT (Internet of Things) for Arduino boards. The set includes i.a.: sensors of light, touch, temperature, servo, display and many others....
Index: SEE-04445
Index: SEE-04445
Arduino MKR Connector Carrier ASX00007 - shield for Arduino MKR
Module for Arduino from the MKR that extends the capabilities of I/O pins. It is designed for modules and sensors from the Grove series. It has 4-pin connectors, works with...
Index: ARD-12947
Index: ARD-12947
Grove - set of 5 female-female 4-pin - 2mm/50cm with latch
A set of five 4-pin Grove wires. They are used to connect sensors with Grove Base Shield v2. The length of the cable is 50 cm. Version with a latch.
Index: SEE-04399
Index: SEE-04399
Grove - ProtoShield - prototype board
Prototype board Grove with a soldered socket. It allows for an easy access to four lines of a standard Grove-S0, S1, VCC and GND series connection cable. The layout of the...
Index: SEE-11344
Index: SEE-11344
Grove - push button with backlight - red
Module from the Grove is equipped with a button with a yellow led. It is powered with the voltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct...
Index: SEE-13661
Index: SEE-13661
Grove Shield for Raspberry Pi Pico - Seeedstudio 103100142
Grove frontend for Raspberry Pi Pico module . Converts Pico GPIO connectors to Grove type connectors such as I2C, UART and digital and analog ports. It allows you to...
Index: SEE-18902
Index: SEE-18902
The Grove module is used to atomize water. It works with a voltage of 5 V. It can be used, among other things, as a humidifier but also allows for more advanced projects where...
Index: SEE-11362
Index: SEE-11362
433 MHz RFM95 radio module of the long range (Long Range: LoRa). It allows for data transmission at the distance of up to 500 m using a piece of wire as an antenna. It a lso...
Index: SEE-09086
Index: SEE-09086
Grove - RGB LED strip WS2813 - digital, addressed - IP65 30LED/m, 9W/m, 5V - 1m
RGB LED bar with Grove connector is equipped with digital, individually addressed WS2813 diodes in density of 30 pcs. per meter. The diodes have been sealed with a layer of...
Index: SEE-15456
Index: SEE-15456
Grove - RGB LED v2.0 - module with RGB diode
Module with RGB diode from Grove. It a llows you to control RGB diode using the digital pins of the microcontroller, and simultaneous connection of even 1024 modules using...
Index: SEE-11299
Index: SEE-11299
Grove - 12-bit Magnetic Rotary Position Sensor / Encoder (AS5600)
The module is equipped with AS5600 magnetic encoder with 12-bit resolution. It has greater accuracy, is non-contact and has no angle limitation, unlike a traditional...
Index: SEE-15546
Index: SEE-15546
Grove - 6-axis accelerometer and gyroscope LSM6DS3 - Seeedstudio 105020012
The module is equipped with a 6-axis accelerometer and a gyroscope based on the LSM6DS3 system with a built-in power regulator. It allows to measure 6 sizes: acceleration X,...
Index: SEE-15559
Index: SEE-15559
Module for transferring a 4-pin Grove connector to an RJ45 connector. The use of an Ethernet cable and Grove modules - RJ45, allows the connection of sensors / modules over a...
Index: SEE-15324
Index: SEE-15324
Grove - Base Hat for Raspberry Pi Zero - shield for Raspberry Pi Zero
Overlay for Raspberry Pi Zero / Zero W based STM32 microcontroller with 12-bit ADC, with Grove connectors, allows to connect sensors and modules from Grove series communicating...
Index: SEE-15459
Index: SEE-15459
Grove - Sensor for measuring EMG muscle activity
Module from the Grove series that allows you to collect the bioelectric signal generated by the human muscles (EMG). The output is an analog signal that can be read using any...
Index: SEE-11308
Index: SEE-11308
See also
- Nfc readers
- Inductive sensors
- RPM sensors
- Led motion detectors
- Tilt sensors
- Accelerometers
- Twilight sensors
- Wifi temperature sensors
- Hall effect sensors
- QR readers
- Piezoelectric sensors
- Optical sensors
- Oxygen sensors
- Resistance sensors
- Door sensors
- Alarm sensors
- 9DoF IMU sensors
- Pressure sensors
- Air quality sensors
- Sound sensors
- Gesture sensors
- Gas sensors
- Limit switches
- Sensors of light and color
- Magnetic sensors
- Medical sensors
- Pressure sensors
- Sensors odbiciowe
- Distance sensors
- Inductive contactless sensors
- Weather sensors
- Liquid level sensors
- Current sensors
- Flow sensors
- Motion sensors
- Temperature sensors
- PT100 temperature probes
- Humidity sensors
- Fingerprint readers
- Encoders
- Photoresistors
- Phototransistors
- IR receivers
- Magnetometers
- Gyros
- Sensor sets
- Gravity modules