Product description: Digital temperature and humidity sensor + stainless steel probe - SHT20 - DFRobot SEN0148
Digitaltemperatureandhumiditysensorincluded with a high qualitystainless steelprobe. The components have been manufactured by DFRobot, and the sensor has a built-inSHT20chip, thanks to which it hashigh precision measurements. The leading technology used in this solution is CMOSens. The sensor has been covered with a metal mesh to increase its resistance to high temperature, pressure and general wear and tear. The probe has a2-wire serial interfaceand internal voltage regulation for easy and fast system integration. The measuring range for temperature is-10°C to 80°Cwith an accuracy of +/- 0.5°C. Humidity, on the other hand, can be measuredfrom 0% to 100% RHwith an accuracy of +/- 5% RH.
Product compatible with Arduino
The manufacturer has prepared a detaileduser guideandlibraryfor Arduino IDE environment.
Digital temperature and humidity sensor + stainless steel probe.
Example connection diagram of sensor using Arduino board. The board is not a part of kit, you can buy it separately in our shop.
Leads description and diagram of connection with the use of controller board
The probe has stripped wires to be connected to the controller module. The sensor is compatible with Arduino and its equivalent boards. Leads should be connected according to the following dependencies:
- redwire - power supply 5 V
- bluewire - system ground GND
- yellowwire - communication interface clock line
- blackwire - line of the communication interface data transmission
Note: In most modules, the ground wire is marked with a black wire. In this case, it is coloured blue.
Technical specifications of the sensor from DFRobot
- Module: digital temperature and humidity sensor
- Embedded circuit: SHT20
- Technology used: CMOSens
- Input voltage range: 5 V
- Power consumption: approximately 0.15 mW
- Communication interface: serial (non-standard I2C)
- Temperature measurement range: from -10°C to 80°C
- Accuracy of measurement: +/- 0.5°C
- Humidity measurement range: 0% to 100% RH
- Measuring accuracy: +/- 5% RH
- Short response time < 8 seconds
- Probe material: stainless steel
- Module dimensions: 49 x 14 mm
- Probe cable length: 900 mm
The sensor is covered with a metal mesh which increases its resistance.
The set consists of a digital sensor and a measuring probe.
Suggested use
- Monitoring of greenhouses and production and storage areas
- Used in the monitoring of stock rooms
- Control element in machine rooms and electronic control cabinets
Kit contents
- Digital temperature and humidity sensor
- Stainless steel measuring probe 90 cm long
In our assortment you will also find otherenvironmental sensors. We invite you to familiarize with the offer.
