Description
Module from the Grove is equipped with a button with a yellow led. It is powered with the voltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct connection of the board to the Raspberry Pi and Arduino. The switch, by default is set to high status and the LED to the low status.
Attention! This product is only available in our market in Poland and cannot be sold to other countries. |
Connection
The module is equipped with Grove interface that facilitates its connection tothe Arduinoalong with the Base Shield v2.0orRaspberry using the Hat from the GrovePi+.
Pin | Description |
---|---|
1)GND | The ground of the system. |
2)VCC | Supply voltage is from 3.3 V to 5 V |
3)SIG2 | The signal output of the status of the button. High, by default. |
4)SIG1 | The signal input of the LEDs. By default, it is low. |
Grove is a series of modules and sensors that are compatible withBase Shields working withArduinoandSTM32 Nucleo. |
Specification
- Supply voltage: from 3.3 V to 5 V
- Supply current of the LED: 50 mA
- Type: normally closed (NC)
- The resistance of the pressed button: < 100 mΩ
- The resistance of the released button: > 100 MΩ
- Dimensions: 40 x 20 x 16 mm
- Weight: 30 g
Useful links |