Product description: SATA M1 disk mounting kit - for Odroid M1 minicomputer
A kit that allows you to mount a 2.5-inch SSD or HDD on Odroid M1 - a single- board minicomputer equipped with a whole range of interfaces. Provides approximately 500 MB / s sequential access. A separate external 12V SATA power supply is required to use the 3.5 inch hard drive. The set includes the HDD Holder, mounting screws and spacers, a power cord and a data cable.
The contents of the mounting kit for the SATA M1 drive.
Installation instructions.
Installation instructions
- Connect the power cord and the SATA data cable to the Odroid M1 minicomputer. Unscrew the two black screws and screw the mounting spacers included in the kit.
- Use the two black screws to connect the HDD Holder and SSD as in picture B.
- Connect the other side of the power cord and SATA data cable to the SSD.
- Attach the HDD Holder to the drive and replace the two black screws.
- Keep the wires in a safe place.
Kit contents
- HDD Holder - 1 piece
- Power cord - 1 piece
- Data transfer cable - 1 piece
- Mounting screws - 5 pieces
- Mounting spacers - 3 pieces
Odroid M1 - minicomputer with Rockchip RK3568B2 processor + 8 GB RAM
Odroid M1 is a single- board minicomputer equipped with a Cortex-A55 quad-core processor (with low energy consumption and high performance) and a Mali-G52 graphics processor. Odroid M1 has 8 GB of RAM and a connector for eMMC memory and microSD cards , Ethernet slot, HDMI and USB 3.0. There is an efficient heat sink around the module, which helps to cool the entire system during operation.
Odroid M1 - minicomputer with Rockchip RK3568B2 processor + 8 GB RAM.
