Description: JetRacer - 4-wheeled AI robot platform with camera and DC drive and OLED display for Nvidia Jetson Nano
Four-wheeled JetRacer robot platform based on Nvidia JetsonNano.The robot is equipped with a camera, which supportsdeep learningtechnologyforobject detection and self-movement. It has a swivel front axle and a main board withOLEDdisplay.Thevehicle supports such platforms as: Nvidia, TensorFlow,OpenCV, Python, TensorRT and Keras and PyTorch. The platformis powered bythree Li-Ion18650batteries(notincluded).Also included in the kit is a map withadrivingtrackand a controller for remotecontrol of the vehicle.
The kit does not include the NvidiaJetson Nanominicomputer required for proper operation of the robot, it can be purchased separately. |
Supported by JetRacer programming platforms.
Deep learning technology
The JetRacer platform is a racing vehicle that usesartificial intelligencethrough the Nvidia Jetson Nano. It uses adeep learning neuralnetwork to enable the vehicle to move independently on the line.
The robot collects route data using a camera connected to the Nvidia Jetson Nano minicomputer. With the next use / passage through the site, the system collects more data and expands the driving model so that the vehicle can move independently in the area.
The operation of the deep learning algorithm.
Arrangement of elements on the tile
The JetRacer has a 4-wheel DC drive, a torsional front axle using a servo, a camera, a motherboard equipped with OLED display, WiFi and Bluetooth module, as well as a battery charging system and a basket for 3 Li-Ion batteries.
The arrangement of the components on the board.
JetRace platform specifications
- Camera resolution: 8 MPx, 3280 x 2464 px
- The angle of view of the camera: 160° FOV
- Engine: 37-520
- Gearbox: 1:10
- Motor supply voltage: 12 V
- Speed: 740 rpm
- Servo: MG996R
- Servo torque: 9 kg*cm
- Servo supply voltage: 4.8 V
- Power to the platform: 3x Li-Ion 18650 battery (not included)
- Display: 0.91" OLED, 128 x 32 px
The set includes
- Platform set
- EVA pads
- Printed engine mounts
- JetRacer motherboard
- Camera IMX219-160
- Acrylic elements
- Servo holder
- AC8265 WiFi chip with antennas and u.FL - SMA adapters
- 2x engine
- 4x a circle
- The link
- Servo MG996R
- Servo attachment hub
- 2x crossover
- 4x bearing
- 4x plastic joint
- 2x axis stick
- 12.6 volt loader
- Controller
- 6-pin cable
- Key
- Screwdriver
- Crossword
- Fan
- MicroSD card reader
- Set of screws
- Map with route 3 x 2 m
Useful links |