- New
- Sale
- Sale
- Reduced price
- Sale
USB type A to USB type C converter with DIP switch - Adafruit 5972
Index: ADA-25265
- Reduced price
- Sale
Relay module Velleman 4 channels - 10A / 250VAC contacts - 5V coil
Index: VEL-13900
- Reduced price
- Sale
Page
Loading...
Electromagnet pulling 12V 24W 6,5kg
The electromagnet is equipped with a 20 mm long bolt, which after receiving a 12 V voltage signal performs a linear pulling movement. During operation the device consumes...
Index: DNG-17766
Index: DNG-17766
Electromagnet pulling 12V 7,8W 0,8kg
The electromagnet is equipped with a 10 mm long bolt, which after receiving a 12 V voltage signal performs a linear pulling movement. The device consumes approx. 0.65 A...
Index: DNG-17759
Index: DNG-17759
Tinycontrol GSMKON-010 - relay board 4x16A/coil 12V for GSM/LAN controller
The module is equipped with 4 Relpol relay a coil supplied with a voltage of 12V, with optical isolation input and mounting holes. The system is designed to work with GSM and...
Index: TNC-08291
Index: TNC-08291
26 IDC gray ribbon cable gray 1.27 mm raster - 30m roll
IDC ribbon cable, 26-vein. Pitch: 1,27 mm. Roller: 30 m.
Index: AKS-10875
Index: AKS-10875
125MHz RFID/NFC Keychain Fob - 10pcs
The RFID identifier in the form of a keychain. Each chip has a unique 32-bit code. The device works at a small distance from the reader, the carrier frequency is 125 kHz .
Index: MOD-07142
Index: MOD-07142
- Reduced price
- SPECIAL OFFERS
Big Push Button 10cm - green - SparkFun COM-11275
A large button with an outside diameter of 10 cm, with a built-in LED to illuminate the dome.
Index: SPF-02250
Index: SPF-02250
Converter USB-UART FTDI FT232RL 3.3V/5V microUSB - SparkFun BOB-12731
Converter that provides communication between the serial interfaces USB and UART. It allows to exchange data between the computer and the systems which use microcontrollers....
Index: SPF-03090
Index: SPF-03090
- Sale
- SPECIAL OFFERS
Ribbon cable 14 colored wires IDC raster 1.27 mm - roll 30.5 m
IDC 14 core ribbon cable. Raster: 1.27 mm. Roll: 30,5 m .
Index: AKS-10948
Index: AKS-10948
Set of lenses for Arducam cameras - M12 mount
A set of ten lenses for cameras from Arducam equipped with M12 mounting. Range of horizontal viewing angle of lens is from 10° to 200°.
Index: ACM-13604
Index: ACM-13604
Servo Hitec HS-485HB Deluxe - standard
Strong standard servo with karbonite gears with increased strength. Speed: 0,18 sec/60 ° . Torque: 6 kg. Dimensions: 39 x 20 x 38 mm. Weight: 45 gr.
Index: MOT-01382
Index: MOT-01382
The holding electromagnet is powered by 24 V with a power of 2.5 W. It holds a mass of 3 kg at a standard acceleration due to gravity of 9.8 m/s 2 . The body diameter is 20...
Index: MOD-07027
Index: MOD-07027
Smoke and flammable MQ-2 gas sensor - semiconductor
Smoke and flammable gases detector with analogue output.
Index: PLL-00548
Index: PLL-00548
ISD1820 audio recording and playback module + speaker
Audio recording module based on the ISD1820 chip . It has a built-in microphone and an attached speaker. Built-in functions allow you to record and play back audio up to 10...
Index: MOD-07025
Index: MOD-07025
ON-OFF switch bistable - 2A / 250V - flat - blue
Flat, bistable switch with blue backlight. Contact load capacity 2 A for 250 V.
Index: DNG-10922
Index: DNG-10922
16 channel relay module with optical insulation - contacts 10A/250VAC - coil 5V
The module has sixteen relays SRD-05 with a coil powered with a voltage of 5 V along with optoelectronic insulation. The system allows you to control the actuators with...
Index: MOD-06940
Index: MOD-06940
Magnetic Encoder Disc for 20D mm Metal Gearmotors, OD 9.7 mm, ID 2.0 mm, 20 CPR (Bulk) - Pololu 3498
Five magnetic disks that are used with quadrature encoders designed for installation in 20D mm motors from Pololu. They help achieve up to 20 impulses per revolution. Outer...
Index: PLL-08257
Index: PLL-08257
Encoder 24 impulse 20mm - EC12 vertical - 5pcs.
Knob in the form of an encoder that allows you to create a simple user interface. The module sends the digital signal to one of the two pins, depending on the direction of...
Index: MOD-06905
Index: MOD-06905
- Sale
- SPECIAL OFFERS
NTC 10kΩ thermistor with 2m cable
Thermistor of NTC type with a resistance of 10 kΩ. The connecting cable has a length of 2 meters.
Index: DNG-10931
Index: DNG-10931
Module with addressed RGB LED WS2812
Module with digital addressed diode RGB WS2812 with outputs with the raster of 2.54 mm, for mounting of goldpin connectors (included). It allows you to get any color with a...
Index: MOD-06904
Index: MOD-06904
Rotary switch 8-position 1 circuit - 30mm
Rotary switch, 8-state for the case, equipped with 9 contacts. The total height is 29.5 mm.
Index: UCC-06162
Index: UCC-06162
Splitter Wire for Servos Y - 30 cm twisted (JR)
Twisted wire splitter for servos with length of 30 cm. The wire allows you to connect two servos to one input of the controller.
Index: KAB-03091
Index: KAB-03091
Plastic foot stand NS30 30x8mm
Round plastic foot made of plastic used as a stand for various types of objects. The diameter of the leg is 30 mm and its height is 8 mm. It has a mounted foam, so it does not...
Index: KAB-07499
Index: KAB-07499
- Sale
- SPECIAL OFFERS
3pin 250V electric cube - orange
The electric 3-pin cube that allows to connect the wires with a voltage of 250 V in a simple way, without the need of using the tools.
Index: LEC-09990
Index: LEC-09990
WiFi antenna 10dB RP-SMA female - 29cm
WiFi 10dB antenna with a female RP-SMA connector, it works with 2.4 GHz frequency. The length is 290 mm.
Index: AKS-10144
Index: AKS-10144