Product description: W6100-EVB-Pico - board with RP2040 microcontroller and Ethernet - WIZnet
Board manufactured by WIZnet and equipped with a Raspberry Pi RP2040 microcontroller and an Ethernet TCP/IP W6100 system. W6100-EVB-PICO supports wired Internet protocols such as TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE and up to 8 independent hardware sockets with 32 kB memory. It supports two types of HOST interfaces - SPI and BUS parallel system. The RP2040 microcontroller has a dual-core ARM Cortex M0+ processor operating at a frequency of up to 133 MHz, 264 kB of RAM (no EEPROM) and an 8 MB SPI Flash chip for storing files.
W6100-EVB-Pico - board with RP2040 microcontroller and Ethernet - WIZnet.
The manufacturer has also prepared a detailed user's guide , which contains a description of individual pins - check it out!
The board has solder pads to which the included connectors should be soldered.
Special features of the plate
- Equipped with a Raspberry Pi RP2040 microcontroller and an Ethernet W6100 system
- Has 30 multifunctional general purpose IOs (4 can be used as ADC)
- Includes built-in 12-bit 500 fs/s analog-to-digital converter (ADC)
- Supports wired internet protocols: TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE
- It simultaneously supports 8 independent SOCKET sockets with 32 KB memory
- It has an internal memory of 16 kB for TX/RX buffers
- It uses the SPI interface
Technical specification of the RP2040 chip
- Dual-core ARM Cortex M0+ clocked at 133 MHz
- 264 kB onboard SRAM
- External Quad-SPI Flash with eXecute In Place (XIP)
- 12-bit analog-to-digital converter (ADC) 500 fps
- Communication interfaces: 2x UART, 2x I2C, 2x SPI, 16x PWM channels
- SWD interface for debugging
- 1x timer with 4 alarms, 1x RTC real time counter
- Supported programming languages: C/C++
Description of the module pins. For more information on the individual pins, see the user's guide .
W6100-EVB-Pico has an Ethernet connector and a USB C port.
Technical specification of the W6100 chip
- Supports wired internet protocols: TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE
- Supports IPv4/IPv6 dual stack
- Simultaneously supports up to 8 independent hardware sockets with 32 kB memory
- Supports socketless commands: ARP, PING, ICMPv6 commands (PING, ARP,DAD,NA,RS) for IPv6 auto-configuration and network monitoring
- Supports Ethernet power off mode and system clock switching to save power
- Supports Wake on LAN over UDP
- 16 KB internal memory for TX/RX buffers
- Auto-negotiation support (full and half duplex, 10 and 100 based)
- Support for Auto-MDIX only in auto-negotiation mode
- Does not support IP address fragmentation
- 3V power supply with 5V I/O signal tolerance
- SPI interface
- MicroUSB connector (type B) for programming and power supply
Kit contents
- W6100-EVB-Pico - board with RP2040 microcontroller - WIZnet
- Goldpin strip - raster 2.54 mm - 2 pieces
Components included in the kit .
Useful links |
