Product description: Gravity - ICP-10111 pressure sensor - DFRobot SEN0517
The temperature and barometric pressure sensor module from DFRobot, features a built-in ICP-10111 sensor, made with MEMS technology. It is powered by 3.3 V to 5.5 V. The module has a Gravity connector. It consumes very little power while being very accurate.
Product compatible with Arduino
The manufacturer has prepared a detailed user guide and a library for Arduino IDE environment.
Gravity - ICP-10111 pressure sensor - DFRobot SEN0517.
Example diagram of pressure sensor connection with DFRduino Uno R3.
Features of the pressure sensor from DFRobot
- Measurement accuracy: ± 1 Pa
- Measurement distortion: 0.4 Pa
Leads description and example connection diagram
The diagram opposite shows the connection of the module to the DFRduino board. Pinouts of ICP-10111 pressure sensor:
- VCC - power supply
- GND - ground
- SCL - I2C interface clock line
- SDA - I2C interface data line
Pressure sensor specification
- Arduinocompatible sensor
- Supply voltage: 3.3 V to 5.5 V
- Current consumption: 2 mA
- Communication interface: I2C
- I2C address: 0x63
- Barometric pressure measurement range: 30 to 110 kPa
- Accuracy of relative barometric pressure measurement: ± 0.01 hPa (950 hPa to 1050 hPa, 25°C)
- Absolute barometric pressure measurement accuracy: ±1 hPa (from 950 hPa to 1050 hPa, 0°C to 65°C)
- Absolute temperature measurement accuracy: ± 0,4°C
- Operating temperature: from -40°C to 85°C
- Dimensions: 30 x 22 mm
Contents of the kit
- Gravity - pressure sensor ICP-10111 V1.0.0
- Sensor connector 2.54 - 4 pin I2C/UART
Module dimensions.
