- New
- Reduced price
- Sale
- Sale
- Sale
SenseCAP A1101 - Vision AI Sensor - LoRaWAN - Seeedstudio 101990962
Index: SEE-22126
- Reduced price
- Sale
- Reduced price
- Sale
ELECTRONICS - Strona 44
Loading...
Cytron Maker Drive MX1508 - two-channel motor controller 9.5V/1A
Simple to use, two-channel DC motor driver with H-bridge. 1 A continuous current per channel (1.5 A momentary). Power supply from 2.5 V to 9.5 V. Output current at 5 V is 0.2 A.
Index: CTN-13999
Index: CTN-13999
Heatsink 40x30x5mm for Raspberry Pi 4 with thermoconductive tape - blue
The 40 x 30 x 5 mm radiator is fully compatible with the Raspberry Pi 4 minicomputer as well as other electronic circuits. It has a layer of self-adhesive and double-sided...
Index: ODS-15696
Index: ODS-15696
Laser distance sensor Lidar TFMini-S UART / I2C - 12m
Laser distance sensor that measures precisely from 0.1 m to 12 m with an accuracy of 0.06 m. The blind spot has been reduced to 10 cm. The sensor communicates through the...
Index: BEN-15862
Index: BEN-15862
Cytron Maker Reflect - Analog IR reflectance sensor
Maker Reflect is a small reflective sensor equipped with an IR diode that sends out an infrared light beam, which returns to the sensor after reflection from the surface and...
Index: CTN-16056
Index: CTN-16056
Grove - water level sensor - 10cm - Seeedstudio 101020635
Sensor to measure the water level in a vessel up to 10 cm using the Arduino module. The measurement is made by volume . The tile is equipped with a Grove connector, for...
Index: SEE-16346
Index: SEE-16346
Pulling electromagnet 12V 14,4W 3,5kg
Tractive solenoid, which requires a voltage of 12 V to operate correctly on the coil. The device, performing linear motion, draws about 1.2 A current. The range of the pin...
Index: DNG-17763
Index: DNG-17763
JST-SH 4pin connecting cable with micro hook - STEMMA QT / Qwiic - Adafruit 5037
Connection cable from Adafruit. It is equipped with STEMMA QT / Qwiic connector on one side and four micro hooks on the other. Each wire is made up of four smaller ones in...
Index: ADA-19917
Index: ADA-19917
Heat shrink tube 2.4 / 1.2 red - 10pcs
Diameter before heat shrink: 2.4 mm, diameter after heat shrink: 1.2 mm. Price for 10 x 1 meter.
Index: NSZ-00084
Index: NSZ-00084
Quartz resonator 12MHz - HC49 - small - 10 pcs.
Quartz resonator in low-profile, through-hole housing.
Index: PAS-00133
Index: PAS-00133
16-pin (2 x 8) angled plug for printing (pitch: 2.54 mm). Price is for 5 pieces.
Index: KAB-00198
Index: KAB-00198
10-pin (2 x 5) angled plug for printing (pitch: 2.54 mm). Price is for 5 pieces.
Index: KAB-00199
Index: KAB-00199
Index: LED-00440
Arduino Proto Shield Mega Rev3 - A000080
Shield for Arduino Mega, allowing you to create your own systems (shields). The model is suitable for the latest versions of the family Arduino Mega Rev3.
Index: ARD-01480
Index: ARD-01480
Index: ETN-01502
Set of 5 wires of different colors with a length of 25 cm ended with connector with hook.
Index: KAB-01554
Index: KAB-01554
Step-Up Voltage Regulator 50W adjustable 12-35V/6A
Upgrade inverter with adjustable output voltage from 12 to 35 V. The permissible input voltage range is 10 V - 32 V and maximum power is 50 W .
Index: MOD-03728
Index: MOD-03728
The fan with the input voltage of 12 V, current consumption of 0.2 A and size of 60 x 60 x 15 mm.
Index: MOT-03874
Index: MOT-03874
Buzzer with generator 30mm 3-24V in a case
Module with buzzer with a generator in a case with put out wires and mounting handles.
Index: EAK-04188
Index: EAK-04188
Switch ON-OFF square 250V/1A - green
Switch with a square attachment with the contact's loading capacity of 1 A for 250 V or 3 A for 125 V.
Index: UCC-04293
Index: UCC-04293
Mini switch Slide MOSFET LV 2-20V/6A - with protection before reverse current - Pololu 2810
The executive module with a MOSFET transistor with a pair of channels P to control devices with higher current consumption than allowed by the control system, for example, a...
Index: PLL-04852
Index: PLL-04852
Capacitive touchscreen Waveshare, 7 " for the Raspberry Pi with a resolution of 1024 x 600 px. Works with Raspberry Pi version 4B, 3B+ 3B+ 2B, 1B+, 1B, 1A and Zero, and Zero W...
Index: WSR-05337
Index: WSR-05337
ScrewShield x2 v2 - screw connectors - Shield for Arduino
Included are two shields, leading out all the Arduino pins on the connectors to which you can connect the cable using the screw connections using screwdriver.
Index: MOD-05343
Index: MOD-05343
Raychem RXEF020 polymer fuse - 72V/0.2A raster 5.1mm - 10pcs
Polymer fuse operating with the voltage of up to 72 V, which allows for the flow of the current of up to 0.2 A. The price is for 10 pieces.
Index: KAB-05475
Index: KAB-05475
Eight-segment display x1 - 14mm green - common anode
Single 8-segment display with digits with points and some characters.
Index: LCD-06440
Index: LCD-06440