Pakiet filamentów Devil Design - czarno-biały PLA Duo - 2szt.
Index: DEV-27746
- New
- Reduced price
- Pack
- Sale
- New
- New
- Sale
- Sale
- Sale
- Sale
- Reduced price
- Sale
- Reduced price
- Sale
- Reduced price
- Sale
ELECTRONICS - Strona 92
Loading...
DFRobot Gravity - digital barometer, pressure and altitude sensor 1250hPa I2C/SPI 3,3-5,5V
Module with digital barometer from Bosch BMP388. The measurement range is from 300 hPa to 1250 hPa relative accuracy of 8 Pa on approx. 0.5 m of altitude. The system is...
Index: DFR-13156
Index: DFR-13156
Power cord extension cord IEC 1.8 m VDE - black
Extension of the power cable with the IEC 320 C13 and IEC 320 C14 plugs with the 1.8 m length, used mostly in PC and server computers and power supplies for laptops and other...
Index: IMP-13207
Index: IMP-13207
Radio transmitter Feather 32u4 RFM95 LoRa Radio - 868MHz - Adafruit 3078
Radio transmitter/receiver operating in the LoRa standard powered with the rechargeable li-pol battery or via USB, it is running at frequencies of 868/915 MHz. Range, when...
Index: ADA-13280
Index: ADA-13280
- Reduced price
- SPECIAL OFFERS
The control module from a Grove series. It has a built-in tact-switch system and pull-down resistor. It communicates with the microcontroller through a digital signal.
Index: SEE-13344
Index: SEE-13344
OdSeven Camera Module Sony IMX219 8MPx 77,6 degree - for Raspberry Pi
Camera module with sensor IMX219 with a resolution of 8 MPx and angle of 77,6°. The module has no PCB. It works with the official camera v2 for the Raspberry Pi.
Index: ODS-13465
Index: ODS-13465
Grove RGB LED Stick - LED RGB 10 x WS2813 Mini 3535
The panel consists of 10 individually addressed RGB LEDs WS2813 Mini-3535 with built-in control unit. LEDs located on the panel are controlled with just one signal pin.
Index: SEE-13662
Index: SEE-13662
LED 3mm holder - plastic concave - 10pcs
Holder for LEDs 3 mm, made of plastic. The subject of the sale is the holder, the LEDs can be purchased separately. Price for 10 pieces.
Index: AKS-13703
Index: AKS-13703
- Sale
- SPECIAL OFFERS
BleBox ProxiSwitch V2 - proximity switch 12-24V
Complete module allows you to turn the device on and off by touch or by gesture. It works with voltage from 12V to 24V and current efficiency up to 5A. It has...
Index: BOX-13725
Index: BOX-13725
STSPIN220 Low-Voltage Stepper Motor Driver Carrier - Pololu 2876
Stepper motor driver powered from 1,8 V to 10 V. Maximum resolution: 1/256 koku. Can operate without heat sink or forced air flow at 1.1 A per phase.
Index: PLL-13822
Index: PLL-13822
Step-Up Voltage Regulator U3V70F5 - 5V 10A - Pololu 2891
Step-up converter with 5 V output voltage. Maximum current up to 10 A. Supply voltage between 2.9 V and 5 V.
Index: PLL-14003
Index: PLL-14003
ACHS-7123 Current Sensor Carrier -30A to +30A - Pololu 4032
Current sensor operating in the range from -30 to 30 A, based on the Hall effect. Input voltage is from 4.5 V to 5.5 V. The sensor is designed to use in systems of 5 V.
Index: PLL-14234
Index: PLL-14234
Grove - LCD display 2x16 characters with backlight (White on Blue)
Monochrome 2 x 16 character LCD display with high brightness backlight from Grove. The module communicates with the control board via the two-row I2C bus. The screen is powered...
Index: SEE-14736
Index: SEE-14736
Antenna Square GPS 2.4V - 5V SMA - 3m
GPS antenna at 1575.42MHz ± 1.02 MHz. Standard cable length is 3 meters. The antenna has a magnetic base so we can place it on a metal surface, e.g. on a car roof. It is...
Index: PSC-14775
Index: PSC-14775
Cytron Shield-MDD10 - two-channel DC motor driver - 7V-30V/10A - Shield for Arduino
A module that allows you to control two DC motors or one stepper motor using Arduino. The overlay allows you to adjust the direction and speed of motors with current...
Index: CTN-14815
Index: CTN-14815
Monostabile switch PB07C 7x7mm - 5pcs
The monostable switch PB07C has dimensions of 7 x 7 mm. It has 6 leads that can be soldered into the PCB. The voltage of the switch is 30 V. The monostable button is an...
Index: AKS-14950
Index: AKS-14950
Two fans 5V with 50x25mm heat sink
Two fans operating at 5 V. The set has a 2-pin connector with a 2,54 mm grid. A heat sink with thermally conductive tape is mounted to the fans. Dimensions of fans with heat...
Index: LON-15059
Index: LON-15059
ProtoBoard - prototyping board 572-poles - double sided - DFRobot FIT0203
Double-sided prototype plate with dimensions of 78 x 58 mm. It is equipped with 572 fields - 22 x 26, the raster is 2.54 mm, it also has 4 mounting holes of 3 mm diameter. It...
Index: DFR-15089
Index: DFR-15089
RS485 - Ethernet converter - Cortex M0 - Waveshare 16529
Device that allows communication between RS485 and Ethernet RJ45 interface. Module can be configured by web page, AT commands, serial protocol and network protocol. It is...
Index: WSR-15133
Index: WSR-15133
RS232/RS485 converter - Ethernet - Cortex M4 - Waveshare 16530
A device allowing communication between RS232 or RS485 and Ethernet RJ45 interfaces. Module configurable via web page, AT commands, serial protocol and network protocol. It...
Index: WSR-15134
Index: WSR-15134
Grove - Variable Color LED v1.1
Module with RGB LED and Grove connector. The color of the LED can be changed by digital signal and PWM, as well as by potentiometers on the board. The module is powered from...
Index: SEE-15454
Index: SEE-15454
Grove - LED RGB module - 20 diodes WS2813 - Seeedstudio 104020170
The module is equipped with 20 RGB WS2813 LEDs . On the board there is a Grove connector for simple connection to the base plate. Each of the LEDs is individually addressed ,...
Index: SEE-15554
Index: SEE-15554
Power supply GLP GPV-35-24 for LED strip 24V/1,5A/36W - waterproof
GPV-35-24 power supply for LED lighting with 24 V output voltage and 36 W. The power supply housing is waterproof. Built-in electronic protections protect the secondary...
Index: WAK-15672
Index: WAK-15672
Dragino LHT65N - Wireless temperature and humidity sensor - LoraWAN
Dragino LHT65N wireless temperature and humidity sensor using long-range LoRaWAN technology for communication. The device has a built-in 2400 mAh battery , which can be used...
Index: SEE-15793
Index: SEE-15793
D36V6ALV - Adjustable Step-down Voltage Regulator 2,5V-7,5V 0,6A - Pololu 3798
A step-down converter operating with an input voltage between 4 V and 50 V . The output voltage is regulated by a built-in potentiometer from 2.5 V to 7.5 V with a maximum...
Index: PLL-15969
Index: PLL-15969