- New
Product description: M1U256 - single-channel DC motor driver 48 V / 2.2 A with connectors - UART interface - Pololu 5062
A driver based on the M1U256 system that allows you to control one DC motor. It uses the UART TTL interface for communication. The module can work with motors supplied with a voltage of 4.5 V to 48 V. The maximum output current per motor is 2.2 A. The controller also withstands current spikes of up to 6.4A for a few seconds. The user can connect several controllers to the same TTL serial bus and extend the project with additional motors. The board has soldered goldpin connectors .
The manufacturer provides a detailed user guide that makes it easy to start working with the module - check it out!
M1U256 - single-channel motor driver DC 48 V / 2.2 A with connectors - UART interface - Pololu 5062.
The driver is based on the M1U256 chip.
Main features of the M1U256 driver
- Control of one DC motor
- UART interface
- Soldered goldpin connectors
- Ability to connect multiple controllers to one serial bus and extend the project with additional motors
- Protection against reverse voltage on the motor supply up to 40 V
- Optional Cyclic Redundancy Check (CRC)
- Configurable motion parameters:
- maximum acceleration/deceleration
- initial speed
- direction change delay
- Eight PWM frequency options from 1kHz to 80kHz
- Protection in case of connection loss
- Configurable automatic error response
- Engine supply voltage measurement (VIN)
- Informative LEDs
M1U256 driver technical specification
- Number of channels: 1
- Supply voltage: from 4.5 V to 48 V
- Operating voltage of the logic part: from 3.0 V to 5.5 V
- Continuous current: 2.2A
- Maximum instantaneous current: 6.4 A
- PWM frequency: 1kHz to 80kHz
- Dimensions: 15.24 x 15.24mm
- Weight: 1.9g
The module has soldered goldpin connectors.
