Raspberry Pi 3B+ GPIO extensions and HAT - Strona 9
1 Wire Pi Zero DS2482 - 1-Wire module for Raspberry Pi
Shield for Raspberry, based on DS2482-100 system, allows you to use the 1-Wire protocol. The module provides conversion to the I2C interface. It has built-in RJ12 connector,...DC Motor Driver HAT V1.0 - 2-channels motor driver 12V/1,2A - HAT for Raspberry Pi - DFRobot DFR0592
Two-channel DC motor controller TB6612FNG operating with voltage from 7 V to 12 V and continuous current 1.2 A per channel and momentary 2 A. The module in the form of an...Pirate Audio 3W Stereo Amp - 3W amplifier with display - AMP for Raspberry Pi - Pimoroni PIM484
Overlay with two DAC chips for the Raspberry Pi minicomputer. The board is equipped with a 3 W stereo audio output , two speaker terminals and a 1.3 " colour IPS display ....Enviro pHAT - temperature, pressure, light intensity and proximity sensor - overlay for Raspberry Pi
Enviro pHAT is an overlay for Raspberry Pi with BME280 and LTR-559 sensors allowing to measure temperature, pressure, light level and proximity sensor. Additionally, the...Dual channel CAN BUS Shield for Raspberry Pi - Seeedstudio 103990563
Overlay by Seeedstudio for Raspberry Pi minicomputers. It supports CAN FD interface with transmission speed up to 8 Mbps , it is faster and more efficient version of...E-paper E-Ink flexible display (D) 2,13'' 212x104px HAT for Raspberry Pi - Waveshare 15084
Shield for Raspberry Pi with a flexible display e-paper of 2.13 " with a resolution of 212 x 104 pixels. It is connected directly to GPIO pins. It communicates via SPI...Pirate Audio Speaker -speaker with display - DAC for Raspberry Pi - Pimoroni PIM485
DAC amplifier cap for Raspberry Pi minicompouter. It has a built-in 1 W / 8 Ω speaker and a 1.3" colour IPS display. Additionally, the board is equipped with 4...Qwiic HAT for Raspberry Pi - SparkFun DEV-14459
Shield, type HAT for Raspberry Pi, facilitating the connection of modules SparkFun via connectors Qwiic. The shield connects the I2C bus on the Raspberry Pi with connectors Qwic.JustBoom Digi Hat - sound card for Raspberry Pi
Shield for Raspberry Pi with high quality S/PDIF interface. It is used in device, the system has a resolution of 24 bit with the speed of 192 kHz. It has the transformer...Audio Amp SHIM - 3W Mono Amplifier for Raspberry Pi - Pimoroni PIM541
A small SHIM overlay for Raspberry Pi minicomputers made by Pimoroni company. The module acts as a 3 W mono amplifier. There is a terminal connector on the board to connect...PiJuice Zero - A Portable Power Platform for Raspberry Pi Zero
Portable power platform for Raspberry Pi Zero minicomputers. When connected to any power source, it acts as a wireless UPS . It uses intelligent power management...GPIO to FPC Breakout pHAT for Raspberry Pi
Trim wyprowadzająca 40-pin GPIO connector on the FPC so that you can connect sensors, wires, etc, with the Raspberry Pi Board. It allows also connection of the display...Unicorn HAT Mini - LED RGB matrix - for Raspberry Pi - Pimoroni PIM498
Overlay for Raspberry Pi made by Pimoroni company. On the board there are 119 RGB LEDs in the form of 17 x 7 matrix . Thanks to the HT16D35A chip it is possible to...ReSpeaker 4-Mic Linear Array Kit for Raspberry Pi
ReSpeaker is a 4 microphone expansion board for Raspberry, designed for AI and voice applications. It allows you to build a powerful device that, among other things, supports...pHAT Stack – Raspberry Pi pins expander - solder yourself kit- Pimoroni PIM321
The pHAT Stack board connects to the Raspberry Pi via a 40-pin cable and increases the minicomputer's pin count by an additional five 40-pin goldpin strips . You can connect 5...