- Reduced price
- Promotion
- Reduced price
- Promotion
- Reduced price
- Promotion
- On sale!
- Promotion
- On sale!
- Promotion
Grove modules - Strona 2
Loading...
Grove - Buzzer - module with active buzzer
Active buzzer module from Grove. It e mits a uniform tone after taking a high position. When using PWM, it can generate different sounds and effects. The power voltage from 4...
Index: SEE-11298
Index: SEE-11298
Module with red LED, fitted with Grove connectors is ideal for working with Arduino. The LED turns on, when the signal pin goes into high state. In addition, on the board...
Index: SEE-11346
Index: SEE-11346
Grove - ProtoShield - prototype board
Prototype board Grove with a soldered socket. It allows for an easy access to four lines of a standard Grove-S0, S1, VCC and GND series connection cable. The layout of the...
Index: SEE-11344
Index: SEE-11344
I2C hub allows you to connect several modules to one I2C bus connector on Base Shield v2 board. Using splitter you can connect 7 sensors from Grove series to one socket.
Index: SEE-04438
Index: SEE-04438
Grove - IR receiver 38kHz 940nm
IR receiver from Grove , operating at a frequency of 38 kHz with a supply voltage from 3.3 V to 5.0 V. Maximum sensitivity is observed for the wave length of 940 nm.
Index: SEE-04419
Index: SEE-04419
Grove - a speaker with a digital interface
Speaker module Grove is a device controlled by the PWM signal. It c an work as a simple buzzer or audio player. The volume is adjustable with the built in potentiometer. The...
Index: SEE-11352
Index: SEE-11352
- Reduced price
- Promotion
Grove - set of 5 female-female 4-pin - 2mm/30cm with latch
A set of five 4-pin Grove wires. They are used to connect sensors with Grove Base Shield v2. Cable length is 30 cm. Version with a latch.
Index: SEE-04398
Index: SEE-04398
Grove - capacitive humidity sensor - corrosion resistant
The device is used to measure the soil moisture by the capacitive detection. It has a built in voltage regulator which provides an operating voltage in the range from 3.3 V to...
Index: SEE-13967
Index: SEE-13967
Grove - Shield for micro:bit v2.0
Grove Shield v2.0 overlay for micro:bit features 4 4-pin connectors for easy connection of Grove series sensors to the minicomputer.
Index: SEE-14132
Index: SEE-14132
- Reduced price
- Promotion
Grove Shield for Raspberry Pi Pico - Seeedstudio 103100142
Grove frontend for Raspberry Pi Pico module . Converts Pico GPIO connectors to Grove type connectors such as I2C, UART and digital and analog ports. It allows you to...
Index: SEE-18902
Index: SEE-18902
Grove - 10kΩ rotary potentiometer linear lower connector
Potentiometer 10 kOhm with linear rotary. It has a 300° range of rotation. It has a 4-pin Grove connector on the other side of the handle. The kit includes a cable adapted...
Index: SEE-04430
Index: SEE-04430
Grove - temperature and humidity sensor DHT11 - Seeedstudio 101020011
The sensor of temperature and humidity DHT11 from the Grove series. The output is a digital signal. The temperature measurement range is from 0 °C to 50 °C and...
Index: SEE-12378
Index: SEE-12378
Capacitive touch sensor based on the module TTP223-b is supplied with the voltage from 2 V to 5.5 V, the output is a digital signal.
Index: SEE-04431
Index: SEE-04431
Grove - Cable Pigtail - 4-pin connection cable - 10cm - Adafruit 5244
Connection cable from Adafruit. On one side it has four isolated wires (each in a different color), and on the other side it has a connector compatible with the Grove...
Index: ADA-21063
Index: ADA-21063
Grove - DS1307 real-time clock I2C
Module from Grove features a real time clock DS1307, which voltage is supplied by a round CR1225 battery (not included) . It allows you to read the time in hours, minutes,...
Index: SEE-13332
Index: SEE-13332
Grove RGB LED Stick - LED RGB 10 x WS2813 Mini 3535
The panel consists of 10 individually addressed RGB LEDs WS2813 Mini-3535 with built-in control unit. LEDs located on the panel are controlled with just one signal pin.
Index: SEE-13662
Index: SEE-13662
Grove - push button with backlight - blue
Module from the Grove is equipped with a button with a blue LED. Powered with the v oltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct...
Index: SEE-13660
Index: SEE-13660
Module from the Grove series, based on the LM386 system and electret microphone. It can be powered with any voltage from 4 V to 12 V. The output is an analog signal. The sensor...
Index: SEE-11350
Index: SEE-11350
Grove - Pi+ StarterKit for Raspberry Pi 4B/3B+/3B/2B
Starter set introducing to the world, IoT (Internet of Things) for the Raspberry Pi. The set includes i.a.: sensors of light, sound, temperature, relay, display and many...
Index: SEE-04447
Index: SEE-04447
Grove - push button with backlight - red
Module from the Grove is equipped with a button with a yellow led. It is powered with the voltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct...
Index: SEE-13661
Index: SEE-13661
Grove - Base Shield for Arduino Nano
Shield for Arduino Nano is a board fully compatible with Seeeduino Nano. It has 8 connectors, so it is possible to connect many devices, sensors, Grove displays using 4-pin...
Index: SEE-14994
Index: SEE-14994
Grove - analog NTC temperature sensor
Analog sensor is compatible with Arduino and Raspberry Pi. It is powered with the voltage from 3.3 V to 5 V. It can measure temperature in the range from -40 °C to 125 °C with...
Index: SEE-11356
Index: SEE-11356
Grove - module with MOSFET transistor
It allows for turning on and off devices that require power from 5V to 15V with a digital signal. Switching frequency up to 5 MHz. It has two mounting holes, two ARK...
Index: SEE-11339
Index: SEE-11339
Grove - push button with backlight - yellow
Module from the Grove is equipped with a button with a yellow led. It is powered with the v oltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct...
Index: SEE-12596
Index: SEE-12596
See also
- Piezoelectric sensors
- RPM sensors
- Oxygen sensors
- Tilt sensors
- Accelerometers
- Inductive sensors
- Hall effect sensors
- Led motion detectors
- Optical sensors
- Twilight sensors
- Resistance sensors
- Door sensors
- Alarm sensors
- 9DoF IMU sensors
- Pressure sensors
- Air quality sensors
- Sound sensors
- Gesture sensors
- Gas sensors
- Limit switches
- Sensors of light and color
- Magnetic sensors
- Medical sensors
- Pressure sensors
- Sensors odbiciowe
- Distance sensors
- Inductive contactless sensors
- Weather sensors
- Liquid level sensors
- Current sensors
- Flow sensors
- Motion sensors
- Temperature sensors
- PT100 temperature probes
- Humidity sensors
- Fingerprint readers
- Encoders
- Photoresistors
- Phototransistors
- IR receivers
- Magnetometers
- Gyros
- Sensor sets
- Gravity modules