- New
- New
- New
- Reduced price
- Sale
- Reduced price
- Sale
- Reduced price
- Sale
- Reduced price
- Sale
- Reduced price
- Sale
ELECTRONICS - Strona 77
Loading...
Module with vibration sensor 801S - regulated
A very sensitive vibration / pulse sensor 801S based on the LM393 system. It has a built-in potentiometer to adjust the sensitivity. It has analog output and the TTL signal. It...
Index: OST-14289
Index: OST-14289
Diode Schottky BAT85 PHI 0,2A / 30V 4NS - 10pcs
Schottky diodes with a maximum current of 200 mA, 30 V backward voltage.
Index: AKS-14582
Index: AKS-14582
Grove - 3 Axis Analog Accelerometer ADXL335
The Grove series module equipped with the ADXL335 is a small, thin 3-axis accelerometer with signal voltage outputs. It measures acceleration with a minimum full scale range of...
Index: SEE-14738
Index: SEE-14738
RFID identification card S102N - 125kHz - compatible with EM4100 - 25pcs
The RFID identifier in the form of a thick, durable card with a hole. The card works with a frequency of 125 kHz . It has 64 bits of ROM memory. The device works at a small...
Index: SSC-14796
Index: SSC-14796
Lanberg USB Cable Type A-C 2.0 blue braid 5A - 0.5m
USB Type A - C 2.0 cable in blue braided material, used for data synchronization and charging of devices with USB type C input, e.g. smartphones, tablets, pendrives, laptops....
Index: IMP-14819
Index: IMP-14819
Gravity URM09 - ultrasonic distance sensor 2-500cm sensor analog - DFRobot SEN0307
Module with ultrasonic distance sensor URM09, with measuring range from 2 cm to 500 cm. Supply voltage is 3.3 V to 5.5 V. The measuring frequency can reach up to 30 Hz. It...
Index: DFR-14859
Index: DFR-14859
The SP107E Bluetooth LED Music Controller for light and music effects, has the ability to adjust the brightness. It has 18 pre-programmed types of music effects addressed to...
Index: DNG-14870
Index: DNG-14870
Lanberg Ethernet Patchcord U/UTP cat. 6 - 5m - yellow
Unshielded U / UTP Category 6 Ethernet cable with a length of 5 meters terminated with RJ45 plugs.
Index: IMP-15077
Index: IMP-15077
Grove - 6-axis accelerometer and gyroscope LSM6DS3 - Seeedstudio 105020012
The module is equipped with a 6-axis accelerometer and a gyroscope based on the LSM6DS3 system with a built-in power regulator. It allows to measure 6 sizes: acceleration X,...
Index: SEE-15559
Index: SEE-15559
Grove - ADC converter for HX711 load cell sensors - Seeedstudio 101020712
Arduino compatible 24-bit ADC converter module allows to read values from pressure sensors. It has built-in amplifier with optional 32 dB, 64 dB and 128 dB gain. On the board...
Index: SEE-15855
Index: SEE-15855
Pirate Audio 3W Stereo Amp - 3W amplifier with display - AMP for Raspberry Pi - Pimoroni PIM484
Overlay with two DAC chips for the Raspberry Pi minicomputer. The board is equipped with a 3 W stereo audio output , two speaker terminals and a 1.3 " colour IPS display ....
Index: PIM-15898
Index: PIM-15898
Cytron Maker Object - Digital distance sensor IR 38kHz
A small digital distance sensor using the IR beam to measure, the sensor's operating range is adjustable. The distance at which it is able to detect objects depends on the...
Index: CTN-16039
Index: CTN-16039
MCP4728 DAC I2C converter - 4 channels + EEPROM - Adafruit 4470
Digital-to-analogue converter based on MCP4728 chip. It allows to obtain 4 analog outputs from any microcontroller equipped with I2C interface, e.g. Arduino. The...
Index: ADA-16457
Index: ADA-16457
Kanthal A1 resistance wire 0,81mm 2,85Ω/m - 9,1m
Kanthal A1 is a type of resistance wire, characterized by high thermal resistance. The wire has a resistance value of 2.85 Ω / m. The wire diameter is 0.81 mm and its length...
Index: AKS-16671
Index: AKS-16671
Touch screen - resistive LCD TFT 3.5 '' 320x240px for Raspberry Pi 4B/3B+/3B - SPI GPIO
Touch screen TFT LCD with a screen diagonal of 3.5 " and resolutions 320 x 480 px . Communication between the minicomputer and the display is done via...
Index: DNG-16726
Index: DNG-16726
- Reduced price
- SPECIAL OFFERS
CS Mount lens 16mm - manual focus - for Raspberry Pi camera - Arducam LN050
The lens cooperates with official Raspberry Pi HQ camera and ArduCam cameras from Sony IMX477/577 series . It is equipped with 16 mm focal length, manual focus and...
Index: ACM-17062
Index: ACM-17062
Logic system CD4001BE 4xNOR - 5pcs
Logic 4 x NOR gateway with operating voltage from 3 V to 18 V. Intended for THT threaded installation. Circuit in DIP14 enclosure. Product sold in a set of 5 pieces.
Index: UCC-17144
Index: UCC-17144
Logic system CD4001 4xNOR - 5pcs
Logic circuit 4 x NOR gate in DIP14 package. Designed for through-hole THT assembly. Operating voltage of the circuit is from 3 V to 18 V. Product sold in a set of 5...
Index: AKS-17145
Index: AKS-17145
Oxygen Sensor I2C - DFRobot SEN0322
Sensor designed for measuring O2 concentration in the environment. The DFRobot product is compatible with 3.3 V and 5 V controllers such as Arduino, ESP32 or Raspberry...
Index: DFR-17378
Index: DFR-17378
AS7341 - 10-Channel Light / Color Sensor Qwiic/I2C - Adafruit 4698
The module is equipped with a 10-channel spectrum sensor, which is the spectrum of visible light. With it you can measure and characterize how different materials absorb and...
Index: ADA-17703
Index: ADA-17703
Pulling electromagnet 12V 4,5kg
An electromagnet which, under the influence of providing a 12-volt signal pulse, performs a continuous rectilinear movement. The device draws a current of approx. 2 A...
Index: DNG-17765
Index: DNG-17765
Case for Xiao Expansion Board - Acrylic - Transparent - Seeedstudio 110010024
Housing for the Xiao Expansion Board and the Xiao Seeeduino main module. Acrylic-made, transparent , mounted using the included nylon spacers and plugs. Easy to assemble ,...
Index: SEE-18805
Index: SEE-18805
Lanberg USB C - USB C cable 2.0 black premium QC 4.0 PD 1,8m
USB Type C - USB Type C cable with a length of 1.8 m . Supported by Quick Charge technology version 4.0 , charges devices up to 2.5 times faster than with standard cables....
Index: IMP-19057
Index: IMP-19057
Electromagnet pushing 12V 2kg 25mm
The pushing electromagnet is powered by 12 V , it can push out a mass of 2 kg with a standard earth acceleration of 9.8 m/s2. The housing diameter is 25 mm and the bolt...
Index: AKS-19283
Index: AKS-19283