Product Description: Holding electromagnet 12V 3W 20 kgf
Holding electromagnet , powered by 12 V. With a standard acceleration due to gravity of 9.8 m/s 2 it supports a mass of 20 kg . The current consumption during operation of the device is approximately 250 mA, the nominal power is 3 W. The device has an M4 installation hole in the housing, and the set also includes an appropriate mounting screw. The electromagnet has dimensions: 34 x 17 mm. The length of the cables with the insulation removed is approx. 30 cm. If you use the device as an actuator controlled by Arduino , remember not to connect it directly to the microcontroller pins. For proper operation of the system, it is necessary to use a relay , opto-isolator or transistor amplifier .
Holding electromagnet 12V 3W 20kgf .
Electromagnet holding a load .
12V Holding Solenoid Specification
- Supply voltage: 12V
- Power: 3W
- Current consumption: approx. 250 mA
- Load capacity: 20 kgf (holds a mass of 20 kg for a gravitational acceleration of 9.8 m/s 2 )
- Cables with stripped insulation at the ends, approx. 30 cm long
- Mounting hole with M4 thread (screw included)
- Dimensions: 34 x 17 mm
- Weight: 83 g
Attention ! The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases. |
Useful links |
