Product Description: Holding electromagnet 12V 6W 55kgf
Holding electromagnet with a rated power of 6 W. Powered by 12 V. Current consumption is approximately 500 mA. The device maintains a mass of 55 kg under standard acceleration due to gravity. The electromagnet has a mounting hole with an M6 thread. The cables that come out are approximately 30 cm long. The dimensions of the product are 50 x 27 mm. The device can be used as an actuator controlled by Arduino . Because the electromagnet draws too much power, it cannot be connected directly to the pins of the microcontroller. One of the following solutions should be used: relay , optocoupler or transistor amplifier .
Holding electromagnet 12V 6W 55kgf .
Electromagnet holding a load .
12V Holding Solenoid Specification
- Supply voltage: 12V
- Power: 6W
- Current consumption: approx. 500 mA
- Load capacity: 55 kgf (holds a mass of 55 kg for a gravitational acceleration of 9.8 m/s 2 )
- Cables with stripped insulation at the ends, approx. 30 cm long
- Mounting hole with M6 thread (screw included)
- Dimensions: 50 x 27 mm
- Weight: 290 g
|
Attention ! The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases. |
Useful links |
