Product Description: Holding electromagnet 24V 2.5W 3 kgf
The holding electromagnet is powered by 24 V with a power of 2.5 W. It holds a mass of 3 kg at a standard acceleration due to gravity of 9.8 m/s 2 . The body diameter is 20 mm and its height is 15 mm, an M4 threaded hole is used for installation.
Magnet specifications
- Supply voltage: 24V
- Power: 2.5 W
- Current consumption: approx. 0.1 A
- Body diameter: 20 mm
- Body height: 15 mm
- Load capacity: 3 kgf (holds a mass of 3 kg for a gravitational acceleration of 9.8 m/s 2 )
- Cables with stripped insulation at the ends, approx. 25 cm long
- Mounting hole with M4 thread (screw included)
- Limit temperature: 130°C
- Weight: 25 g
Electromagnet holding 24V 2.5W 3kgf.
The device can be used as an actuator controlled by any microcontroller , e.g. Arduino . Please note that the electromagnet draws too much power to connect directly to a microcontroller pin. For this purpose, a relay , optocoupler or transistor amplifier can be used.
Attention ! The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases. |
Useful links |
