Grove modules - Strona 2
Grove - Buzzer - module with active buzzer
Active buzzer module from Grove. It e mits a uniform tone after taking a high position. When using PWM, it can generate different sounds and effects. The power voltage from 4...Grove - precipitation / water sensor
The Grove sensor used to detect the presence of water or its quantity. It is powered with the voltage of 5 V. It can be used to detect the presence, level or absence of water.Grove - a set of 2 female-female 4-pin - 50cm
A set of two 4-pin Grove cables , 50 cm long . M odel dedicated to the M5Stack series , which allows to combine developer modules with Unit modules. The...Grove - IR receiver 38kHz 940nm
IR receiver from Grove , operating at a frequency of 38 kHz with a supply voltage from 3.3 V to 5.0 V. Maximum sensitivity is observed for the wave length of 940 nm.Grove - a speaker with a digital interface
Speaker module Grove is a device controlled by the PWM signal. It c an work as a simple buzzer or audio player. The volume is adjustable with the built in potentiometer. The...- Reduced price
- Promotion
Grove - ProtoShield - prototype board
Prototype board Grove with a soldered socket. It allows for an easy access to four lines of a standard Grove-S0, S1, VCC and GND series connection cable. The layout of the...Grove - set of 5 female-female 4-pin - 2mm/30cm with latch
A set of five 4-pin Grove wires. They are used to connect sensors with Grove Base Shield v2. Cable length is 30 cm. Version with a latch.Grove - SW-420 vibration sensor
Module with high sensitivity vibration sensor from Grove series. When the sensor is at rest, the output of the output transmitted is at a constant high signal (high) and the...Grove - 10kΩ rotary potentiometer linear lower connector
Potentiometer 10 kOhm with linear rotary. It has a 300° range of rotation. It has a 4-pin Grove connector on the other side of the handle. The kit includes a cable adapted...Grove - temperature and humidity sensor DHT11 - Seeedstudio 101020011
The sensor of temperature and humidity DHT11 from the Grove series. The output is a digital signal. The temperature measurement range is from 0 °C to 50 °C and...Grove - Shield for micro:bit v2.0
Grove Shield v2.0 overlay for micro:bit features 4 4-pin connectors for easy connection of Grove series sensors to the minicomputer.- Reduced price
- Promotion
Grove - a set of 5 female-female 4-pin - 20cm cables
A set of five 4-pin Grove cables. They are used to connect M5Stack series developer modules with caps and Unit modules. The cable has 4 lines: two for data...Grove - Base Hat for Raspberry Pi - shield for Raspberry Pi 4B/3B+/3B
Overlay for Raspberry Pi 4B / 3B+ / 3B based STM32 microcontroller with 12-bit ADC, with Grove connectors, allows the connection of sensors and modules from the Grove...Grove - capacitive humidity sensor - corrosion resistant
The device is used to measure the soil moisture by the capacitive detection. It has a built in voltage regulator which provides an operating voltage in the range from 3.3 V to...Grove - DS1307 real-time clock I2C
Module from Grove features a real time clock DS1307, which voltage is supplied by a round CR1225 battery (not included) . It allows you to read the time in hours, minutes,...Grove - Pi+ StarterKit for Raspberry Pi 4B/3B+/3B/2B
Starter set introducing to the world, IoT (Internet of Things) for the Raspberry Pi. The set includes i.a.: sensors of light, sound, temperature, relay, display and many...Grove RGB LED Stick - LED RGB 10 x WS2813 Mini 3535
The panel consists of 10 individually addressed RGB LEDs WS2813 Mini-3535 with built-in control unit. LEDs located on the panel are controlled with just one signal pin.Grove - push button with backlight - blue
Module from the Grove is equipped with a button with a blue LED. Powered with the v oltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct...Grove - analog NTC temperature sensor
Analog sensor is compatible with Arduino and Raspberry Pi. It is powered with the voltage from 3.3 V to 5 V. It can measure temperature in the range from -40 °C to 125 °C with...Grove - push button with backlight - yellow
Module from the Grove is equipped with a button with a yellow led. It is powered with the v oltage from 3.3 V to 5 V. It has the Grove connector that allows for the direct...See also
- Twilight sensors
- Wifi temperature sensors
- Hall effect sensors
- QR readers
- Piezoelectric sensors
- Optical sensors
- Oxygen sensors
- Resistance sensors
- Door sensors
- Nfc readers
- Inductive sensors
- RPM sensors
- Led motion detectors
- Tilt sensors
- Accelerometers
- Alarm sensors
- 9DoF IMU sensors
- Pressure sensors
- Air quality sensors
- Sound sensors
- Gesture sensors
- Gas sensors
- Limit switches
- Sensors of light and color
- Magnetic sensors
- Medical sensors
- Pressure sensors
- Sensors odbiciowe
- Distance sensors
- Inductive contactless sensors
- Weather sensors
- Liquid level sensors
- Current sensors
- Flow sensors
- Motion sensors
- Temperature sensors
- PT100 temperature probes
- Humidity sensors
- Fingerprint readers
- Encoders
- Photoresistors
- Phototransistors
- IR receivers
- Magnetometers
- Gyros
- Sensor sets
- Gravity modules