- Reduced price
- Sale
- Sale
- Sale
- Reduced price
- Sale
ELECTRONICS - Strona 109
Loading...
LED indicator 12V DC - 8mm - green
LED indicator, working voltage 12 V DC. It has a diameter of 8 mm.
Index: LED-08986
Index: LED-08986
LED indicator 12V DC - 12mm - yellow
LED light working voltage 12 V DC. It has a diameter of 12 mm.
Index: LED-08997
Index: LED-08997
LED indicator 12V DC - 19mm - red with a buzzer
The light operates with a voltage of 12 V DC. It has a diameter of 19 mm.
Index: LED-09008
Index: LED-09008
Waterproof headlamp equipped with a diode COB LED 3 W with brightness of luminous flux 150 LM. The flashlight has three modes: 100%, 25% and flashing.
Index: NSZ-09073
Index: NSZ-09073
Screen DPI - LCD IPS 7'' 1024x600px for Raspberry Pi - Waveshare 12885
Screen Waveshare 7 " for the Raspberry Pi with a resolution of 1024 x 600 px. Works with any 40-pin version of the Raspberry Pi via the GPIO pins and DPI interface. The device...
Index: WSR-09100
Index: WSR-09100
GPS USB/TTL module for Raspberry
GPS module based on the L80-R-39 system. It supports 66 search channels and 22 tracking channels. It is working with the voltage of 3.3 V - 5 V. The module has the USB and the...
Index: DFR-09383
Index: DFR-09383
Solenoid Valve 12V 0,02-0,08MPa- 1'' - DCF-HS1B
The device supports the control of fluid flow using a computer or microcontroller. The valve is powered with the voltage of 12 V.
Index: MOD-09449
Index: MOD-09449
XA1110 - MediaTek MT3333 10Hz GPS module - I2C / UART - SparkFun GPS-14414
GPS module based on MediaTek MT3333 chipset. It communicates via I2C or UART interface. The update frequency is 10 Hz, the sensitivity is165 dBm. The applied system can track...
Index: SPF-10104
Index: SPF-10104
- Sale
FlexiForce Pressure Sensor - 100lbs - SparkFun SEN-08685
Pressure sensor reduces its resistance when the force put to its tip, increases. Sensor with a length of 216 mm, the maximum pressure is approx. 45 kg.
Index: SPF-10112
Index: SPF-10112
- Sale
GSM antenna 18x22mm - self-adhesive - 15cm
Antenna operating in the GSM band, it has U. FL connector. It operates at frequencies from 800 MHz to 1900 MHz. It has a layer of self-adhesive tape. Dimensions: 18 x 22 mm....
Index: AKS-10143
Index: AKS-10143
Solid state relay SSR-40A 480VAC / 40A - 32VDC
Single-phase solid -state relay SSR with a voltage of 480 V AC and 32 V DC. The rated current is 40 A.
Index: AKS-10219
Index: AKS-10219
NeoPixel - diode LED WS2812B 5mm - 5 pieces - Adafruit 1938
LED RGB 5 mm WS2812B with integrated control unit allows you to control devices using fast PWM to adjust the color from 24-bit palette. Set of 5 pieces.
Index: ADA-10617
Index: ADA-10617
Miniature boost converter module supplied with voltage from 3 V to 16 V . The output voltage is set to 3.3 V . Maximum current 1,5 A. Dimensions: 15 x 13 x 6 mm. The voltage...
Index: PLL-10674
Index: PLL-10674
Miniature boost converter module supplied with voltage from 3 V to 16 V . The output voltage is set to 3.3 V . Maximum current 1,5 A. Dimensions: 15 x 13 x 4 mm. The...
Index: PLL-10676
Index: PLL-10676
OLED 1,3'' 128x64px module for Raspberry Pi 4/3+/3/2/Zero - Waveshare 13890
Shield for Raspberry Pi and Jetson Nano with blue OLED display with a diagonal of 1.3" and a resolution of 128 x 64 px. The screen is based on SH1106 driver, it communicates...
Index: WSR-10752
Index: WSR-10752
ON-OFF switch monostable - PBW-16BPW - 2A 250V - flat green / red
Monostable flat switch with the green/red backlight. Contact load is 2 A for 250 V.
Index: AKS-10818
Index: AKS-10818
DFRobot - dual digital potentiometer 100 kΩ
The digital potentiometer is a type of mixed IC signal which is able to dynamically change the internal resistors via MCU. It can be used for applications such as dimming of...
Index: DFR-10838
Index: DFR-10838
26 IDC gray ribbon cable gray 1.27 mm raster - 30m roll
IDC ribbon cable, 26-vein. Pitch: 1,27 mm. Roller: 30 m.
Index: AKS-10875
Index: AKS-10875
Ribbon cable 20 gray IDC, raster 1.27mm - roll 30.5m
IDC 20 core ribbon cable. Raster: 1.27 mm. Roll: 30,5 m .
Index: AKS-10951
Index: AKS-10951
Filament Spectrum PETG 1,75mm 1kg - Bloody Red
Filament made of PETG is used as a cartridge for 3D printers. The diameter is 1.75 mm. The set includes 1kg filament in color Bloody Red, length of approx. 340 m. It requires a...
Index: SPC-11052
Index: SPC-11052
Filament Spectrum PETG 1,75mm 1kg - Deep Black
Filament made of PETG is used as a cartridge for 3D printers. The diameter is 1.75 mm. The set includes 1kg filament in color Deep Black, length of approx. 340 m. It requires a...
Index: SPC-11054
Index: SPC-11054
DFRobot Gravity - TEMT6000 analog light sensor
Analog ambient light sensor TEMT6000, compatible with Arduino. The sensor allows to determine the light density and reflects the analog voltage signal back to Arduino. The...
Index: DFR-11253
Index: DFR-11253
DFRobot Gravity - digital sound generator - buzzer
Digital buzzer module for Arduino and Raspberry Pi, which can be controlled via low and high status. When changing the frequencies of the buzzer, you can hear a different...
Index: DFR-11263
Index: DFR-11263
DFRobot Gravity - digital IR transmitter
Digital IR transmitter from the Gravity, operating at a frequency of 38 kHz with a voltage of 5 V. The module communicates with an IR transmitter, after pairing the modules.
Index: DFR-11268
Index: DFR-11268