- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
Light Up Board is a module of the capacitive, touch, dimmed and contactless light on a round printed circuit board with six white LEDs. The device can operate in one of the modes of illumination and does not require programming knowledge. It is powered through a microUSB connector.
Board can be connected withelectric paint, expanding its capabilities.
6 modes of operation
Light Up Board lets you choose one from six working modes. Depending on the mode, the built-in electrodes respond differently to touch.
- The touch- board illuminates after touching the appropriate pin.
- Dimmer switch- uses 6 electrodes that make it possible to set different brightness levels of light.
- Closeup- during holding the button, the brightness of the LEDs depends on the touching the second button.
- Candle- LEDs behave like the lit candles.
- Turn- after pressing, the light rotates in a circle.
- The cube- module simulates a dice roll and displays the result via number of lit LEDs.
Specification
- Microcontroller: ATMega 88
- Touch sensor: MPR121
- Supply voltage: from 4.4 V to 5.25 V via microUSB
- Current consumption: up to 200 mA
- Working voltage: 3.3 V DC
- Capacitive electrodes: 6
- Flash memory: 8 KB
- SRAM: 1 KB
- EEPROM: 512 B
- Clock Speed: 8 MHz
| The manufacturer provides technical support at [email protected] |
Useful links |
