- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
Set for creating a humanoid robotRQ HunobyRobobuilder. The kit includes: 16 DoF, serial bus, IR and sound sensors, USB connector and wireless controller to control the robot.
Key features
- Perfect for education, entertainment, football robots and tournament robots
- Simple installation instructions step by step
- Simple way of connection
- Includes IR and sound sensor
- Contains sample programs for the robot and the Scratch software
- Working with parts and frames RQ KIT
- Includes a wireless IR controller for robot control
Motherboard
The robot was equipped with the motherboard RQ Smart Controller, based on the core ARM Cortex TM-M3 32-bit, it can store up to 21 sequence of motions (11 pre-defined) and 10 autonomous behavior. Thanks to a sound and IRsensors, the robot can detect obstacles and analyze its environment.
- Clock Frequency: 24 MHz
- Memory: 64 KB
- Supply voltage: 2 V to 3.6 V
- Built-in microphone and buzzer
- Connectors for servos, motors, and sensors
Servos
The robot was equipped with 16 high quality servos SAM-3, which makes the RQ Hunno robot quick and agile. Servos have a transparent case with blue LED backlight. LEDs in addition to lighting effects also perform diagnostic functions, inform about the correct connection of wires.
- Supply voltage: 4 V to 12 V
- Torque: 3 kgf*cm
- Speed: 80 rpm
- Interface: TTL UART
- Gear ratio: 243
- Max output: 0.62 V
- Weight: 22 g
Programming
The robot is programmed through a graphical interface Builder Scratch using the programming unit in the C language. The manufacturer provides a complete sample program for the robot's motion. Thanks to the Motion Builder software, you can program the robot's motion.
Specification
- Power: battery Li-Pol 11 V
- DOF: 16
- Sensors: IR, sound
- Sound output: 9 melodies
- Work time: 50 to 60 minutes
- Bluetooth: supported
- Height: 18 cm
- Weight: 620 g
Set includes
- 1x is a 32-bit microcontroller
- 16x servo
- 1x battery Li-Pol
- 1x power adapter 22 Volt
- 1x obstacle detection sensor
- 1x sound sensor (inside the controller)
- 1x Bluetooth module
- 1x communication bus (for Bluetooth connection)
- 1x controller, IR remote control
- 1x serial-USB adapter
- 1x flash drive
- 1x user manual
- Set of rivets, bolts, hinges, body parts
- Wires for connection
Useful links |
