- EOL
|
Attention! The product has been discontinued. Check other products incategory. |
Description
Heated bed for 3D printer RepRap. It has two heaters with a supply voltage of 12 V or 24 V. Stand should be used in combination withglass plate. The device does not have a built-in temperature sensor in the form of a thermistor.
Connection
The device has three pins, can be supplied with the voltage of 12 V or 24 V. The pin layout shown below is also printed on the bed.
| Pin | 12 V | 24 V |
|---|---|---|
| 1 | PLUS | N/C* |
| 2 | MINUS | PLUS |
| 3 | MINUS | MINUS |
*N/C (not connected) output must be left unconnected.
| Detailed information can be found on the page of the RepRap project. |
Specification
- Supply voltage: 12 V or 24 V
- Construction:
- Laminate FR4 thickness 1.6 mm
- Two layers copper thickness 35 µm
- Red soldermask with two sides
- White screen printing on two sides
- No thermistor temperature sensor
- Resistance: 1.0 Ohms to 1.2 Ohms
- Four mounting holes diameter: 3mm
- Dimensions: 215 x 215 mm
Useful links |
