Set of filaments Spectrum Material Mix 1,75 mm 1,25 kg - 5 colors
Index: SPC-22333
- Reduced price
- Promotion
GJ-M12-25IR(5MP)-3 M12 25mm 5Mpx lens - for Raspberry Pi camera
Index: RPI-22483
- Reduced price
- Promotion
- Reduced price
- Promotion
- Reduced price
- Promotion
List of products by brand SparkFun - Strona 22
Loading...
FlexiForce Pressure Sensor - 1lb - SparkFun SEN-08713
Pressure sensor reduces its resistance when the force put to its tip, increases. Sensor with a length of 216 mm, the maximum pressure is approx. 0.45 kg.
Index: SPF-10114
Index: SPF-10114
- EOL
Qwiic female-female cable with 4-pin plug - 20cm - SparkFun PRT-14428
4-pin cable, length 20 cm . Terminated on both sides with JST Qwiic 4-pin connector with 1 mm pitch.
Index: SPF-10110
Index: SPF-10110
- EOL
EL Tape - electroluminescent tape - red - 1m - SparkFun COM-10796
EL Tape is a flexible, electroluminescent tape from plastic which includes a layer phosphor and glows with a neon gleam during power supply with the correct voltage. Tape...
Index: SPF-11188
Index: SPF-11188
- EOL
USB-C Breakout - SparkFun BOB-15100
The connector allows you to connect the USB pins from the cable with the C plug for breadboard. The module is suitable for standard breadboards and connecting cables available...
Index: SPF-13623
Index: SPF-13623
- EOL
ESP32 Thing Plus DMX - driver for LED strips - SparkFun DEV-15110
A device for transmitting and receiving DMX data. Voltage supply 5 V.
Index: SPF-14180
Index: SPF-14180
- EOL
IoT Starter Kit with Blynk Board - SparkFun KIT-14682
Starter kit SparkFun IoT is an introduction to the world of Internet of Things (IoT). It allows, i.a. for monitoring the local weather conditions, providing information about...
Index: SPF-14181
Index: SPF-14181
- EOL
XBee Explorer with voltage regulator - SparkFun WRL-11373
A circuit to connect the XBee module. It has voltage regulator 3.3 V and logic level converter 5 V to 3.3 V. Works with all XBee modules from series 1 and 2.5, standard and pro.
Index: SPF-01599
Index: SPF-01599
- EOL
Module XBee 802.15.4 1mW Series 1 - Wire Antenna
XBee Series 1 module with a 1 mW transmitter with an antenna as a cable. It operates within a wireless network range of up to 100 m. XBee Series 1 requires no...
Index: SPF-01604
Index: SPF-01604
- EOL
USB RFID Reader - SparkFun SEN-09963
Easy to use module for RFID reader with USB interface. It works with systems from the series: ID-2, ID-3, ID-12 and ID-20. In the computer, it is seen as a virtual serial COM...
Index: SPF-01678
Index: SPF-01678
- EOL
Arduino Pro 328 module - 3,3V/8 MHz - SparkFun DEV-10914
Module based on Arduino® Uno with ATmega328 system, is characterized by small size and low profile. It has 32 KB of Flash memory, 2 KB of RAM 14 digital of I/os, 6 of which can...
Index: SPF-01679
Index: SPF-01679
- EOL
Pogo Pin - concave - SparkFun PRT-10114
The spring pin with a concave head, designed for connecting and testing the modules with the pins on the goldpin straps without the need of soldering.
Index: SPF-01756
Index: SPF-01756
- EOL
Li-Pol single cell charger 1S 3.7V miniUSB - SparkFun PRT-12711
Simple charger for 1-purpose lithium-polymer batteries with a nominal voltage of 3.7 V, powered via a miniUSB connector or DC socket.
Index: SPF-01706
Index: SPF-01706
- EOL
MiniUSB type B 5 pin - connector for breadboard - SparkFun BOB-09966
Connector allows you to connect the pinouts of the mini USB from the cable with connector type B to the breadboard. The module is suitable for a standard breadboard and...
Index: SPF-01934
Index: SPF-01934
- EOL
USB Host - Shield for Arduino - SparkFun DEV-09947
Module allows you to connect and control any USB device from Arduino at full speed standard.
Index: SPF-02214
Index: SPF-02214
- EOL
RedBot - MMA8452Q I2C digital accelerometer - SparkFun SEN-12589
Addition to the RedBot Kit that allows you to measure acceleration in three axes: X, Y, Z. It has an adjustable measurement range: ±2, ±4 or ±8 g, and it is supplied with the...
Index: SPF-02412
Index: SPF-02412
- EOL
Big EasyDriver A4988 35V 1,4A stepper motor driver with voltage regulator - SparkFun ROB-12859
Stepper motor controller based on A4988. Powered from 8 - 35 V, with a maximum current consumption of 1.4 A per coil. Maximum resolution: 1/16 steps. It has a built-in voltage...
Index: SPF-02408
Index: SPF-02408
- EOL
MiniGen Shield - signal generator Shield for Arduino Pro Mini - SparkFun BOB-11420
The module can generate the following signals: sine, square and triangle with a frequency up to 3 MHz with an amplitude of 1 Vpp. The system communicates via the SPI bus. The...
Index: SPF-02413
Index: SPF-02413
- EOL
ATmega328 module + MLX90614 IR thermometer - SparkFun SEN-10740
Development kit with ATmega328 microcontroller with preinstalled Arduino bootloader. The system operates with a voltage of 3.3 V at a frequency of 8 MHz. The board also...
Index: SPF-02407
Index: SPF-02407
- EOL
Standard Servo Gripper - Actobotics Standard Gripper Kit B - SparkFun ROB-13175
Holder made of plastic with a hole, adapted for single beds. The total length is 127 mm, width 33 mm, and the maximum opening of 152 mm.
Index: SPF-02958
Index: SPF-02958
- EOL
XBee Wireless KIT - Shield for Arduino - SparkFun KIT-13197
Includes two modules for wireless communication XBee Series 1 with a transmitter with power of 1 mW, a cap for Arduino XBee Shield and Explorer USB to connect to computer.
Index: SPF-03011
Index: SPF-03011
- EOL
MicroView OLED display - compatible with Arduino - SparkFun DEV-12923
MicroView is the OLED display of 64 x 48 px with an integrated Atmega328P microcontroller and uploaded bootloader Arduino Uno. The module can display messages, data from...
Index: SPF-03069
Index: SPF-03069
- EOL
Bluetooth 4.0 Low Energy Module - BLE Mate Gold 2 - SparkFun WRL-13019
Bluetooth 4.0 Low Energy (BLE) module communicates via serial UART (RX, TX) interface with a speed of 9600 bps. Its working range is up to 30 m, it is powered by a voltage in...
Index: SPF-03318
Index: SPF-03318
- EOL
Mux Shield II GPIO expander for Arduino - SparkFun DEV-11723
Shield for Arduino that allows you to increase the number of pins up to 48 pins that can operate as digital inputs/outputs and analog inputs. Board moves the connectors on its...
Index: SPF-03398
Index: SPF-03398
- EOL
Logomatic v2 - data logger on microSD card - SparkFun WIG-12772
System with the microcontroller LPC2148 ARM Cortex 32-bit, equipped with a slot for memory cards microSD and microUSB connector for connection. When connected to the computer,...
Index: SPF-04368
Index: SPF-04368
- EOL