2-channel 10A back box relay - Matter - Android/iOS app - RTX MRS2
Index: REM-24788
- Reduced price
- Sale
- Sale
- Sale
- Sale
- Sale
- Reduced price
- Sale
ELECTRONICS - Strona 41
Loading...
Logic system CD74ACT14E - 6x inverter with Schmitt trigger
Logic system 6 x inverter with working voltage from 4.5 V to 5.5 V, in DIP 14 case.
Index: UCC-11764
Index: UCC-11764
WiFi module ESP-01M ESP8285 - 11GPIO, ADC, PCB Antenna
Wi-fi module based on the chip ESP8285. It works in the wi-fi 802.11 b/g/n standard. It is equipped with 18 pins - pitch of 1,6 mm, 11 of which are GPIO, 1 ADC and UART. It has...
Index: DNG-12252
Index: DNG-12252
- Reduced price
- SPECIAL OFFERS
SATA Data III wire (6GB / s) M / M 50cm - red
Cable SATA III complete with connectors at both ends, allows to achieve data transfer at 6 Gbps. It allows you to connect a CD drive or hard disk to the motherboard of the...
Index: IMP-13199
Index: IMP-13199
Grove module with a monochrome OLED 0,96" display with a resolution of 128 x 64 px. It communicates through I2C interface and is based on the SSD1308Z system. The product is...
Index: SEE-13338
Index: SEE-13338
Cytron Maker Drive MX1508 - two-channel motor controller 9.5V/1A
Simple to use, two-channel DC motor driver with H-bridge. 1 A continuous current per channel (1.5 A momentary). Power supply from 2.5 V to 9.5 V. Output current at 5 V is 0.2 A.
Index: CTN-13999
Index: CTN-13999
Heatsink 40x30x5mm for Raspberry Pi 4 with thermoconductive tape - blue
The 40 x 30 x 5 mm radiator is fully compatible with the Raspberry Pi 4 minicomputer as well as other electronic circuits. It has a layer of self-adhesive and double-sided...
Index: ODS-15696
Index: ODS-15696
Laser distance sensor Lidar TFMini-S UART / I2C - 12m
Laser distance sensor that measures precisely from 0.1 m to 12 m with an accuracy of 0.06 m. The blind spot has been reduced to 10 cm. The sensor communicates through the...
Index: BEN-15862
Index: BEN-15862
Cytron Maker Reflect - Analog IR reflectance sensor
Maker Reflect is a small reflective sensor equipped with an IR diode that sends out an infrared light beam, which returns to the sensor after reflection from the surface and...
Index: CTN-16056
Index: CTN-16056
Grove - water level sensor - 10cm - Seeedstudio 101020635
Sensor to measure the water level in a vessel up to 10 cm using the Arduino module. The measurement is made by volume . The tile is equipped with a Grove connector, for...
Index: SEE-16346
Index: SEE-16346
Pulling electromagnet 12V 14,4W 3,5kg
Tractive solenoid, which requires a voltage of 12 V to operate correctly on the coil. The device, performing linear motion, draws about 1.2 A current. The range of the pin...
Index: DNG-17763
Index: DNG-17763
JST-SH 4pin connecting cable with micro hook - STEMMA QT / Qwiic - Adafruit 5037
Connection cable from Adafruit. It is equipped with STEMMA QT / Qwiic connector on one side and four micro hooks on the other. Each wire is made up of four smaller ones in...
Index: ADA-19917
Index: ADA-19917
Seeed Xiao RA4M1 - ARM Cortex M4 - Seeedstudio 102010551
Xiao RA4M1 is a compact development board with a 32-bit Renesas RA4M1 microcontroller (ARM Cortex M4, 48 MHz). It offers 256 KB Flash memory, 32 KB SRAM, 8 KB EEPROM . It...
Index: SEE-25608
Index: SEE-25608
Heat shrink tube 2.4 / 1.2 red - 10pcs
Diameter before heat shrink: 2.4 mm, diameter after heat shrink: 1.2 mm. Price for 10 x 1 meter.
Index: NSZ-00084
Index: NSZ-00084
Quartz resonator 12MHz - HC49 - small - 10 pcs.
Quartz resonator in low-profile, through-hole housing.
Index: PAS-00133
Index: PAS-00133
16-pin (2 x 8) angled plug for printing (pitch: 2.54 mm). Price is for 5 pieces.
Index: KAB-00198
Index: KAB-00198
10-pin (2 x 5) angled plug for printing (pitch: 2.54 mm). Price is for 5 pieces.
Index: KAB-00199
Index: KAB-00199
Index: LED-00440
Arduino Proto Shield Mega Rev3 - A000080
Shield for Arduino Mega, allowing you to create your own systems (shields). The model is suitable for the latest versions of the family Arduino Mega Rev3.
Index: ARD-01480
Index: ARD-01480
- Reduced price
- SPECIAL OFFERS
Index: ETN-01502
Set of 5 wires of different colors with a length of 25 cm ended with connector with hook.
Index: KAB-01554
Index: KAB-01554
Step-Up Voltage Regulator 50W adjustable 12-35V/6A
Upgrade inverter with adjustable output voltage from 12 to 35 V. The permissible input voltage range is 10 V - 32 V and maximum power is 50 W .
Index: MOD-03728
Index: MOD-03728
The fan with the input voltage of 12 V, current consumption of 0.2 A and size of 60 x 60 x 15 mm.
Index: MOT-03874
Index: MOT-03874
Buzzer with generator 30mm 3-24V in a case
Module with buzzer with a generator in a case with put out wires and mounting handles.
Index: EAK-04188
Index: EAK-04188
Switch ON-OFF square 250V/1A - green
Switch with a square attachment with the contact's loading capacity of 1 A for 250 V or 3 A for 125 V.
Index: UCC-04293
Index: UCC-04293