CAN Bus Module - MCP2515 - SPI - hat for Feather - Adafruit 5709
Index: ADA-22888
- Reduced price
- Sale
- Reduced price
- Sale
- Sale
- Sale
ELECTRONICS - Strona 105
Loading...
GPS USB/TTL module for Raspberry
GPS module based on the L80-R-39 system. It supports 66 search channels and 22 tracking channels. It is working with the voltage of 3.3 V - 5 V. The module has the USB and the...
Index: DFR-09383
Index: DFR-09383
Solenoid Valve 12V 0,02-0,08MPa- 1'' - DCF-HS1B
The device supports the control of fluid flow using a computer or microcontroller. The valve is powered with the voltage of 12 V.
Index: MOD-09449
Index: MOD-09449
GSM antenna 18x22mm - self-adhesive - 15cm
Antenna operating in the GSM band, it has U. FL connector. It operates at frequencies from 800 MHz to 1900 MHz. It has a layer of self-adhesive tape. Dimensions: 18 x 22 mm....
Index: AKS-10143
Index: AKS-10143
Solid state relay SSR-40A 480VAC / 40A - 32VDC
Single-phase solid -state relay SSR with a voltage of 480 V AC and 32 V DC. The rated current is 40 A.
Index: AKS-10219
Index: AKS-10219
NeoPixel - diode LED WS2812B 5mm - 5 pieces - Adafruit 1938
LED RGB 5 mm WS2812B with integrated control unit allows you to control devices using fast PWM to adjust the color from 24-bit palette. Set of 5 pieces.
Index: ADA-10617
Index: ADA-10617
Miniature boost converter module supplied with voltage from 3 V to 16 V . The output voltage is set to 3.3 V . Maximum current 1,5 A. Dimensions: 15 x 13 x 6 mm. The voltage...
Index: PLL-10674
Index: PLL-10674
Miniature boost converter module supplied with voltage from 3 V to 16 V . The output voltage is set to 3.3 V . Maximum current 1,5 A. Dimensions: 15 x 13 x 4 mm. The...
Index: PLL-10676
Index: PLL-10676
OLED 1,3'' 128x64px module for Raspberry Pi 4/3+/3/2/Zero - Waveshare 13890
Shield for Raspberry Pi and Jetson Nano with blue OLED display with a diagonal of 1.3" and a resolution of 128 x 64 px. The screen is based on SH1106 driver, it communicates...
Index: WSR-10752
Index: WSR-10752
ON-OFF switch monostable - PBW-16BPW - 2A 250V - flat green / red
Monostable flat switch with the green/red backlight. Contact load is 2 A for 250 V.
Index: AKS-10818
Index: AKS-10818
DFRobot - dual digital potentiometer 100 kΩ
The digital potentiometer is a type of mixed IC signal which is able to dynamically change the internal resistors via MCU. It can be used for applications such as dimming of...
Index: DFR-10838
Index: DFR-10838
26 IDC gray ribbon cable gray 1.27 mm raster - 30m roll
IDC ribbon cable, 26-vein. Pitch: 1,27 mm. Roller: 30 m.
Index: AKS-10875
Index: AKS-10875
Ribbon cable 20 gray IDC, raster 1.27mm - roll 30.5m
IDC 20 core ribbon cable. Raster: 1.27 mm. Roll: 30,5 m .
Index: AKS-10951
Index: AKS-10951
DFRobot Gravity - TEMT6000 analog light sensor
Analog ambient light sensor TEMT6000, compatible with Arduino. The sensor allows to determine the light density and reflects the analog voltage signal back to Arduino. The...
Index: DFR-11253
Index: DFR-11253
DFRobot Gravity - digital sound generator - buzzer
Digital buzzer module for Arduino and Raspberry Pi, which can be controlled via low and high status. When changing the frequencies of the buzzer, you can hear a different...
Index: DFR-11263
Index: DFR-11263
DFRobot Gravity - digital button Tact Switch - white
Digital monostable switch with 3-pin connector. It is powered with the voltage from 3.3 V to 5 V, it works with Arduino modules.
Index: DFR-11278
Index: DFR-11278
DFRobot Gravity - adapter for the GP2Y1010AU0F dust sensor
Adapter for the direct connection of the sensor GP2Y1010AU0F using the Gravity interface for Arduino without additional modules and the prototype board.
Index: DFR-11282
Index: DFR-11282
Grove - L298N - two-channel motor controller 15V / 1A
Grove series module equipped with a two-channel H-bridge L298N , controlled by ATmege 8L. The circuit allows to regulate the direction of rotation of motors with maximum...
Index: SEE-11320
Index: SEE-11320
Grove - infrared thermometer OTP-538U IR
Module from the Grove series, based on a sensor OTP-538U which, to measure the temperature, is using the analysis of infrared radiation in the range from -10 °C to 100 °C. It...
Index: SEE-11324
Index: SEE-11324
Grove - RS-06WD reflectance sensor v1.1
Module from the Grove is equipped with the reflective sensor RS-06WD. It consists of LED emitting the infrared light and phototransistor of high sensitivity. It is supplied...
Index: SEE-11331
Index: SEE-11331
Servo Bonnet - 16-channel PWM I2C driver for Raspberry Pi - Adafruit 3416
Overlay for Raspberry Pi to control 16 servos . The chip generates PWM signals up to 1.6 kHz with 12-bit precision. The board is designed to fit Raspberry Pi 2 x 20...
Index: ADA-11419
Index: ADA-11419
Inductive proximity sensor LJ18A3-8-Z / CY 8mm 6-36V
Inductive, digital proximity sensor with a cable with the length of 100 cm and nuts to facilitate mounting. It detects metal at a distance of up to 8 mm. The object...
Index: DNG-11870
Index: DNG-11870
WiFi module ESP8266 with an e-paper screen connector - compatible with Arduino - Waveshare 14138
Universal board for e-paper displays with built-in wi-fi ESP8266 module. Board compatible with Arduino. The supply voltage is 5 V, it has the SPI 3-wire and 4-wire interface....
Index: WSR-11924
Index: WSR-11924
TB67H420FTG Dual/Single Motor Driver Carrier - Pololu 2997
Single channel DC motor controller. Continuous current per channel 2.6 A (momentary up to 5 A). Supply voltage from 4.5 V to 28 V .
Index: PLL-12059
Index: PLL-12059
DFRobot OLED display blue 0,96" 128x64px - I2C - for FireBeelte
OLED blue display with a diagonal of 0.96" and a resolution of 128 x 64 pixels, with 2 built-in buttons and a joystick. Screen based on SSD1360 driver works with voltages of...
Index: DFR-12357
Index: DFR-12357