- New
- Reduced price
- Sale
- Sale
- Sale
- Reduced price
- Sale
Raspberry Pi 500+ Kit - US 16GB RAM 2,4GHz + official accessories
Index: RPI-27276
- Reduced price
- Sale
ELECTRONICS - Strona 27
Loading...
Relay module Iduino 4 channels - 10A/250VAC contacts - 5V coil
Module with four SRD-05 relays with a 5 V coil and optical insulation of the input as well as mounting holes. The system allows you to control the actuators by means of...
Index: OST-14480
Index: OST-14480
Membrane keypad - 1 blue key - self-adhesive
The keyboard with one key in blue has been equipped with a self-adhesive tape which allows to place the keyboard on any surface and in any place. The connectors of the...
Index: DNG-16988
Index: DNG-16988
LED 3mm green - 10pcs. - justPi
A set of 10 pieces of light emitting diodes (LED) in green , with a lens diameter of 3 mm. The LED is the most popular diode. It emits radiation in the visible light range....
Index: JUS-19987
Index: JUS-19987
10-pin socket (2x5), straight, for printing (pitch: 2.54 mm). Price for 5 pieces.
Index: KAB-00191
Index: KAB-00191
ARK connector KF301 raster 5,0mm 3 pin (-) - 5pcs
Screw, clamp, 3-pin conector. Pitch of 5 mm. Height of 10 mm. The screw for the flat screwdriver (-).
Index: KAB-00808
Index: KAB-00808
The module that facilitates the connection of the SD card to the main board (e.g. Arduino or STM32Discovery). It is powered with the voltage of 5 V or 3.3 V. The communication...
Index: MOD-01507
Index: MOD-01507
WiFi module ESP-12E + NodeMCU v2 - 4MB
Wi-fi module, based on ESP-12E ESP8266. On Board, 10 GPIO ports (each of which can handle PWM, I2C and 1-wire), built-in 10-bit ADC and a Converter USB-UART. It has installed...
Index: SEE-04450
Index: SEE-04450
Inveo - RFID-USB-DESK reader - Unique 125kHz
Inveo module for reading data from RFID devices in the Unique 125 kHz standard. The reader connects to the USB port. The system is seen as a virtual COM port. It has 3 LEDs and...
Index: INV-09123
Index: INV-09123
Disk for optical encoders - 25mm
Disk of optical encoder is designed for installation in engines with a shaft with the size of 5 x 4 mm. The outer diameter is equal to 25 mm.
Index: DNG-12457
Index: DNG-12457
Wifi module ESP-07S ESP8266 - 9 GPIO, ADC, U. FL Connector
ESP-07S module based on ESP8266 chip communicating in 802.11 b/g/n Wi-Fi standard at 2.4 GHz. This is an improved version of the ESP-07 module, compared to its...
Index: DNG-16184
Index: DNG-16184
MicroHDMI cable - HDMI 2.0 original for Raspberry Pi 4/5 - 2m - black
Officially licensed by the Raspberry Pi Foundation microHDMI cable to connect RPi 4 or RPi 5 minicomputer with monitor. 2 m long model in black .
Index: RPI-16337
Index: RPI-16337
Electromagnet holding 12V 6W 55kgf
Holding electromagnet with a rated power of 6 W. Powered by 12 V. Current consumption is approximately 500 mA. The device maintains a mass of 55 kg under standard...
Index: DNG-17578
Index: DNG-17578
Pulling electromagnet 12V 0,5kg
A device whose task is to perform linear motion - pulling, after giving a 12 V voltage signal. The electromagnet draws about 0.6 A current. The range of the pin is 5 mm....
Index: DNG-17757
Index: DNG-17757
JustPi THT CF carbon resistor 1/4W 1,2kΩ - 30pcs.
The set consists of 30 resistors. The electronic elements are designed for THT through-hole mounting. Resistance is 1.2 kΩ and tolerance is 5%.
Index: JUS-20011
Index: JUS-20011
AP63203 - step-down BabyBuck voltage regulator - 3,3V 2A - SparkFun COM-18357
Step-down converter , made by SparkFun. The AP63203 voltage regulator changes the input voltage from 3.8 V to 32 V to the output: 3,3 V . The current capacity of the...
Index: SPF-20235
Index: SPF-20235
Quartz resonator 4MHz - HC49 - low - 10 pcs.
The quartz resonator in the small through hole case.
Index: PAS-00132
Index: PAS-00132
Step-Down Voltage Regulator D24V6F5 - 5V 0,6A - Pololu 2107
Converter, type step down with an output voltage of 5 V. The maximum current up to 600 mA. Supply voltage ranges from 6 V to 42 V.
Index: PLL-01349
Index: PLL-01349
Index: LED-01457
Diode Power LED Star 1 W - white with heat sink
Diode Power LED Star 1W with a heat sink. Emits light in a cool white color, close to daylight.
Index: LED-01616
Index: LED-01616
Memory card M1AA Goodram microSD 16GB 100MB/s UHS-I class 10 with adapter
Popular format of micro SD/SDHC card, which is used in smartphones, tablets, cameras. Product of class 10 with UHS-I interface from company Goodram. Speed of the read : up...
Index: KAP-02123
Index: KAP-02123
D-SUB 25 socket for wire - 5pcs.
D-SUB 25 male connector for cable used for example as LPT parallel port connector.
Index: KAB-05000
Index: KAB-05000
WiFi module ESP8266 Wemos NodeMCU V3 32Mb - 11 GPIO, ADC, PWM
Wi-fi module based on ESP8266. On Board 11 GPIO ports (each of which can handle PWM, I2C and 1-wire), built-in ADC and USB-UART converter. It has installed NodeMCU software...
Index: GRL-10908
Index: GRL-10908
Push Button 6cm - yellow - flat
Large, flat button with an outer diameter of 6 cm with built-in LED illuminating the dome.
Index: DNG-10987
Index: DNG-10987
RTC DS1307 + 32kb EEPROM 24C32 I2C - real-time clock with memory
Module with real time clock and backup battery. It allows you to read the time in hours, minutes, and seconds, date: month, day, year. It has 32 KB of EEPROM. The...
Index: GRL-12507
Index: GRL-12507