Page
Electromagnet pulling 12V 24W 6,5kg
The electromagnet is equipped with a 20 mm long bolt, which after receiving a 12 V voltage signal performs a linear pulling movement. During operation the device consumes...Electromagnet pulling 12V 7,8W 0,8kg
The electromagnet is equipped with a 10 mm long bolt, which after receiving a 12 V voltage signal performs a linear pulling movement. The device consumes approx. 0.65 A...Module with addressed RGB LED WS2812
Module with digital addressed diode RGB WS2812 with outputs with the raster of 2.54 mm, for mounting of goldpin connectors (included). It allows you to get any color with a...ON-OFF switch bistable - 2A / 250V - flat - blue
Flat, bistable switch with blue backlight. Contact load capacity 2 A for 250 V.Grove - dust / purity air sensor PM2.5 PPD42NS - 5V PWM
Sensor of dust allows you to monitor the purity of the air. It is equipped with a sensor that can detect PM 2.5 particles with a diameter above 1 μm, such as cigarette smoke....16 channel relay module with optical insulation - contacts 10A/250VAC - coil 5V
The module has sixteen relays SRD-05 with a coil powered with a voltage of 5 V along with optoelectronic insulation. The system allows you to control the actuators with...Converter USB-UART FTDI FT232RL 3.3V/5V microUSB - SparkFun BOB-12731
Converter that provides communication between the serial interfaces USB and UART. It allows to exchange data between the computer and the systems which use microcontrollers....- Sale
- SPECIAL OFFERS
NTC 10kΩ thermistor with 2m cable
Thermistor of NTC type with a resistance of 10 kΩ. The connecting cable has a length of 2 meters.Set of lenses for Arducam cameras - M12 mount
A set of ten lenses for cameras from Arducam equipped with M12 mounting. Range of horizontal viewing angle of lens is from 10° to 200°.WiFi antenna 10dB RP-SMA female - 29cm
WiFi 10dB antenna with a female RP-SMA connector, it works with 2.4 GHz frequency. The length is 290 mm.Plastic foot stand NS30 30x8mm
Round plastic foot made of plastic used as a stand for various types of objects. The diameter of the leg is 30 mm and its height is 8 mm. It has a mounted foam, so it does not...- Sale
- SPECIAL OFFERS
Adapter DC 5.5/2.1mm with switch - 4 plugs
Extension cable with one female 5,5 / 2,1 mm slot and four male 5.5 / 2.1 mm plugs. It has mounted switch on the cable. It can be used, i.a. to power many LED strips from one...Servo Hitec HS-485HB Deluxe - standard
Strong standard servo with karbonite gears with increased strength. Speed: 0,18 sec/60 ° . Torque: 6 kg. Dimensions: 39 x 20 x 38 mm. Weight: 45 gr.- Sale
- SPECIAL OFFERS
Ribbon cable 14 colored wires IDC raster 1.27 mm - roll 30.5 m
IDC 14 core ribbon cable. Raster: 1.27 mm. Roll: 30,5 m .3pin 250V electric cube - orange
The electric 3-pin cube that allows to connect the wires with a voltage of 250 V in a simple way, without the need of using the tools.ISD1820 audio recording and playback module + speaker
Audio recording module based on the ISD1820 chip . It has a built-in microphone and an attached speaker. Built-in functions allow you to record and play back audio up to 10...Splitter Wire for Servos Y - 30 cm twisted (JR)
Twisted wire splitter for servos with length of 30 cm. The wire allows you to connect two servos to one input of the controller.Rotary switch 8-position 1 circuit - 30mm
Rotary switch, 8-state for the case, equipped with 9 contacts. The total height is 29.5 mm.26 IDC gray ribbon cable gray 1.27 mm raster - 30m roll
IDC ribbon cable, 26-vein. Pitch: 1,27 mm. Roller: 30 m.ON-OFF switch monostable - PBW-16BPW - 2A 250V - flat green / red
Monostable flat switch with the green/red backlight. Contact load is 2 A for 250 V.125MHz RFID/NFC Keychain Fob - 10pcs
The RFID identifier in the form of a keychain. Each chip has a unique 32-bit code. The device works at a small distance from the reader, the carrier frequency is 125 kHz .- Reduced price
- SPECIAL OFFERS
