- Sale
- Sale
- Sale
- Sale
- Reduced price
- Sale
List of products by brand Akso - Strona 37
Loading...
USB standard connector, type A in SMD surface soldered housing.
Index: KAB-00419
Index: KAB-00419
Electrolytic capacitor 330uF/35V 10x12mm 105C THT - 10pcs.
Through hole electrolytic capacitor of 330 uF / 35 V. Pins' pitch: 5 mm. Size: Ø10 x 12 mm. Price is for 10 pieces.
Index: PAS-04120
Index: PAS-04120
Liquid level sensor CMW55 - magnetic
The sensor allows you to control the water level in the tank. It consists of a float with a magnet which, under the force of buoyancy, is shifted, causing a short circuit of...
Index: SES-03730
Index: SES-03730
- Discontinued product
Infrared receiver TSOP4838 - 38kHz
IR receiver TSOP4838, it is operating at a frequency of 38 kHz.
Index: SES-01047
Index: SES-01047
Soldering stand with tin holder ZD-10S
Universal stand for soldering iron suitable for most resistance soldering irons. It has a tin holder and a place for the sponge (included).
Index: LUT-02268
Index: LUT-02268
Small metal motor powered by 3.7 V. Idle current 60 mA. Dimensions: 8 x 4 mm. The output is a wire with the insulation removed.
Index: MOT-08497
Index: MOT-08497
Electric cube self-locking 2 pin 2mm 10A/380V - 10 pcs
The 2-pin electric self-locking cube allows you to connect the wires with a voltage of 380 V with the flow of current up to 10 A. Connection pitch is 10 mm, the maximum...
Index: KAB-03717
Index: KAB-03717
- Discontinued product
M2.5 Self-Locking Nuts - 10 pcs.
Self locking / self stopping nut M2.5 is a fastener used in screw connections. This type of nut is equipped with a polyamide insert that increases friction and prevents...
Index: NSZ-06451
Index: NSZ-06451
The magnet is horseshoe shaped with a size of 59 x 49 x 9 mm. It helps, for example, capture small screws.
Index: MAG-08496
Index: MAG-08496
Round self-adhesive feet 20mm - 4 pieces
Self-adhesive feet - round props for electronic modules, about 20mm in diameter. Price for 4 PCs.
Index: AKS-11521
Index: AKS-11521
Case for connector D-SUB 9 - 2pcs.
Shield screwed to the D-SUB 9 connector along with the set of screws.
Index: KAB-02481
Index: KAB-02481
Index: BAT-06380
Laminate FR4 double-sided size L
FR4 double sided laminate with a thickness of about 1,5 mm. Copper layer 35 um. Sheet dimensions are 130 x 200 mm, with a tolerance of up to 20 mm.
Index: LUT-01054
Index: LUT-01054
Self-adhesive round feet 11mm - 4pcs
Self-adhesive round feet - props for electronic modules, with an 11 mm diameter. Price for 4 PCs.
Index: ETN-01337
Index: ETN-01337
Speaker MG6-15 0.1W 32Ohm - 15x6x3mm
Speaker with power of 0.1 V, the resistance of 32 Ohms and a size of 15 x 6 x 3 mm.
Index: EAK-03478
Index: EAK-03478
Contact plate to check the layout before PCB design. 840 has a hole (pitch 2.54 mm), which can be fastened to the chip and module.
Index: PLY-00890
Index: PLY-00890
Reflector for photoelectric sensor 6x4cm
Reflector for photoelectric sensors. The size of the refelector - 40 x 60 x 8 mm.
Index: AKS-10611
Index: AKS-10611
IDC 14 pin female-female cable - 30 cm
Universal female cable with the length of 30 cm, ended with 14-pin IDC slots with the pitch of 2.54 mm(standard goldpin) which can be used to create different connections.
Index: KAB-01247
Index: KAB-01247
A small metal motor powered by 3 V. Idle current 80 mA. Dimensions: 17,3 x 7 mm. Shaft diameter: 0,8 mm.
Index: MOT-04722
Index: MOT-04722
Self-adhesive round feet low 8mm - 4 pcs.
Self-adhesive feet - round props for electronic modules, with an 8 mm diameter. Price for 4 PCs.
Index: ETN-01335
Index: ETN-01335
ON-OFF bistable switch - PBW-12APW - 2A / 250V - flat red + resistor
A flat bistable switch with red backlight. Contact load is 2 A for 250 V. Set also includes a resistor.
Index: AKS-10800
Index: AKS-10800
- Discontinued product
ON-OFF switch monostable - PBW-12B - 2A 250V flat
The monostable flat switch with the load capacity of the contacts: 2 A for 250 V.
Index: NSZ-09793
Index: NSZ-09793
Eight-segment display x1 - 14mm red - common anode
Single 8-segment display of digits with points and some characters.
Index: LCD-06438
Index: LCD-06438
FR4 single sided laminate with a thickness of approximately 1.5 mm. Copper layer 35 um. Sheet dimensions are 90 x 200 mm, with a tolerance of 20 mm.
Index: LUT-00932
Index: LUT-00932