- Reduced price
- Sale
- Reduced price
- Sale
- Sale
- Sale
ELECTRONICS - Strona 84
Loading...
Fingerprint reader - with STM32F205 32-bit - Waveshare 8552
Module with fingerprint reader communicating through serial interface UART (RX, TX). It has a memory where you can store up to 1000 fingerprints of different people and export...
Index: WSR-05622
Index: WSR-05622
Plastic case Kradex Z3 - 110x150x70mm black
Four-part, universal housing designed for storing electronic circuits. The product was made of polystyrene. For mounting the housing, use the mounting screws included in the...
Index: KDX-05747
Index: KDX-05747
Eight-segment display x2 - 14mm blue - common anode
Dual 8-segment display two digits along with points and some characters.
Index: LCD-06435
Index: LCD-06435
Eight-segment display x1 - 14mm blue - common anode
Single 8-segment display digits with point and some characters.
Index: LCD-06439
Index: LCD-06439
ArduCam-Mini OV2640 2MPx 1600x1200px 60fps SPI - camera module for Arduino
Camera module for Arduino 2 MPx with a resolution of 1600 px x 1200 and speeds up to 60 frames per second. It extends the capabilities of the microcontroller with the ability...
Index: ACM-06556
Index: ACM-06556
Electric cube 12pin 12mm 20A/250V
The 12-pin electric cube allows you to connect the wires with a voltage of 250 V with the flow of current up to 20 A. Connection pitch is 10.5 mm, the maximum diameter of the...
Index: KAB-06896
Index: KAB-06896
DFRobot Gravity: Non-contact Liquid Level Sensor
The sensor determines the liquid level without dipping into the liquid. Due to the lack of contact with the liquid, the module is suitable for level measurement of hazardous...
Index: DFR-06931
Index: DFR-06931
Goodram All in One M1A4 - microSD 64GB memory card 100 MB/s class 10 + adapter + OTG reader
Practical and functional set of Goodram company, consisting of: micro SD/SDHC memory card class 10, adapter and USB and OTG reader. Read speed: up to 100 MB/s, write speed:...
Index: KAP-06948
Index: KAP-06948
Cable HDMI 2.0 - 1m - official for Raspberry Pi - white
HDMI cable officially licensed by the Foundation Raspberry Pi that lets you connect the minicomputer with the monitor. Supports Full HD and 4K, its length is 1 m.
Index: KAB-07041
Index: KAB-07041
DFRobot - 12V Solenoid Valve 1/2"
The enables the control of the liquid flow using a computer or microcontroller. The valve is supplied with the voltage of 12 V. It is closed to connect the power supply of 12...
Index: DFR-07423
Index: DFR-07423
High temperatura probe PT100 - 7x50mm
Waterproof analogue sensor with the high temperature working in the range from -200 °C to 420 °C. The output is resistance dependent on temperature. Probe length is 50 mm.
Index: SES-07468
Index: SES-07468
Toroidal transformer Indel TST20/006 20W 230V/2x14V
Toroidal transformer made by Indel. The primary voltage is 230 V, the secondary is 2 x 14 V. The power is equal to 20 VA.
Index: MOD-07878
Index: MOD-07878
The device allows to perform a linear - pulling motion with a voltage signal of 12 V. The range of the bolt is approximately 10 mm.
Index: MOD-08072
Index: MOD-08072
10-segment LED Bar Display OSX10201-RGB1
10-segment LED display, the range of colors is 4 x red, 3 x green, 3 x blue. It can be used for example as a temperature gauge or liquid level.
Index: LED-08171
Index: LED-08171
The angular plug is for mounting on the cable. It has the ground.
Index: KAB-08175
Index: KAB-08175
TTP224 4-way Capacitive Touch Switch Module
Capacitive touch sensor based on the TTP224 module. It is powered by a voltage from 2.4 V to 5.5 V, the output is a digital signal. It has 4 buttons with LED signaling.
Index: MOD-08235
Index: MOD-08235
MQ-135 alcohol, benzine, ammonia sensor - semiconductor
Module with sensor MQ-135 detecting benzene, alcohol and smoke . It is powered with the voltage from 2.5 V to 5 V. It has digital and analog output, making it compatible with...
Index: MOD-08243
Index: MOD-08243
Tinycontrol-111 - LAN controller LK3.9 HW - digital I/O / 1-wire / I2C
A device that acts as a WWW server. It allows for reading sensors and remote control of 6 outputs. This version has many improvements over the V2 version, e.g. signal...
Index: TNC-08287
Index: TNC-08287
Power supply S-36-12 - for LED strips - 12V / 3A / 36W
Stable, switched-mode industrial power supply for powering LED strips. Voltage: from 100 V to 240 V. Output voltage: 12 VDC. Output current: 3 A. Equipped with a terminal...
Index: ZAS-09645
Index: ZAS-09645
Copper heatsink set for Raspberry Pi 4/3/2/B+/Zero - 8pieces
The set includes two copper heatsinks, which can cool the minicomputer Raspberry Pi 3 B, 2 B, B+ and Zero. They are suitable for chips located on the board and emit the...
Index: DNG-10048
Index: DNG-10048
Arcade Concave Button 3,5cm - red - SparkFun COM-09336
Concave button with an outer diameter equal to 35 mm and a height of 65 mm. To the button attached is a simple limit switch.
Index: SPF-10078
Index: SPF-10078
Arcade Concave Button 3,5cm - green - SparkFun COM-09341
Concave button with an outer diameter equal to 35 mm and a height of 65 mm. To the button attached is a simple limit switch.
Index: SPF-10083
Index: SPF-10083
WiFi antenna 3dB SMA male - 52mm
Wi-fi 3 dB antenna with the SMA male connector operating at the 2.4 GHz frequency. The antenna length is 52 mm and a diameter is 10 mm.
Index: AKS-10146
Index: AKS-10146
SanDisk Ultra Fit - memeory USB 3.1 Pendrive 64GB
USB 3.0 Ultra Flair memory from SanDisk with capacity of 64 GB. It is equipped with a small case. The device has a 5 years warranty.
Index: BAL-10584
Index: BAL-10584