Page - Strona 118
SATA data and power cable for Odroid H2/H3/H4
A set containing SATA cables for the complete connection of an HDD / SDD to a Odroid H2 / H3 / H4 chassis with the possibility of installing the drive. Includes SATA power cord...SHT31 - digital humidity and temperature sensor I2C - Adafruit 2857
Humidity and temperature sensor powered by the voltage from 3 V to 5.0 V with I2C interface. The measurement of temperature is from -40 °C to 125 °C, humidity from 0 to 100 % RH.AL2437 banana socket - black - 4mm - 5pcs
Banana slot in black color with the length of 33 mm with the hole diameter of 4 mm. Set of 5 pcs slots.RPi Relay Board - 3 relays - cap for Raspberry Pi - Waveshare 11638
Cap fitted to connectors of Raspberry Pi GPIO in version 4B, 3B+, 3B, 2B, B+ and A+, with three relays with parameters of 250 V / 10 A. Board has a screw connector....Testing clip for testing SMD measuring component Uni-T UT-L01
Testing clip for measuring the values of SMD elements, which allows to perform measurements with one hand, e.g. for the resistor in the housing SMD, for LEDs, etc.Logic system CD4093BE 4xNAND with Schmitt trigger - 5pcs
Logic system with four NAND gates, with Schmitt's derailleur gears at the output, preventing the system from waking up. The voltage of the system is from 3 V to 18 V. The...Breadboard - 400 holes transparent
Breadboard is used for creating and testing electronic circuits without soldering. Version with 400 cells, the size of 82.5 x 53 mm, with a transparent body. Stripes denoting...Zener diode 1.3W 5.1V - 10pcs.
Zener diode with a power of 1.3 W and a voltage of 5.1 V. The set includes 10 pieces.DC socket 5,5/2,1mm with 1 m wire
DC φ5.5 x 2.1 mm slot (for AC adapter) with 2-vein cable with the length of 1 m with the removed insulation at the end.Eight-segment display x1 - 14mm red - common anode
Single 8-segment display of digits with points and some characters.Ultrasonic distance sensor HC-SR04 2-200cm + mounting bracket
Ultrasonic sensor operating in the range from 2 cm to 200 cm with special bracket for mounting. It is powered with the voltage of 5 V. The output is a signal whose duration is...Soldering station WEP 937D - 40W
Grotto WEP soldering station 937D with power of 40W and adjustable temperature from 200 °C to 480 °C. It has a LED display which shows the set temperature of the soldering tip.Case for Raspberry Pi 4B/3B+/3B/2B x3 - open
The transparent, open side case allows the installation of three Raspberry Pi mini-computers in 4B, 3B+, 3B, 2B and 1B+ versions using the supplied screws.Case justPi for Raspberry Pi 4B - aluminum with two fans - blue
Blue case for Raspberry Pi 4B minicomputer made entirely of aluminum and equipped with two fans operating at 5V. The construction of the case makes its whole surface act as...DIP switch 4-pole - red - 5pcs.
Table slide switch with four levers. Pins pitch: 2.54 mm Height: 5.5 mmLimit switch mini with lever - WK621 - 5 pcs.
Limit switch with curved lever with the length of 18 mm. The maximum operating parameters: voltage of 250 V and current of 5 A. 5 pcs.Electrolytic capacitor 470uF/25V 10x16mm 105C THT - 10pcs
Through hole electrolytic capacitor of 470 uF / 25 V. Pins' pitch: 3 mm. Size: Ø8 x 12 mm. Price is for 10 pieces.RGB LED Bar WS2811 - digital, addressable - IP65 30 LED/m, 7.2W/m, 12V - 5m
Individually addressable RGB LEDs located in a 5 m bar with a density of 30 diodes per meter. Each pixel consists of three RGB LEDs can emit a color from 24-bit palette. To...Connecting cables male-male 10cm colored - 50pcs
Set of 10 connection cables with a length of 10 cm in different colours.Raspberry Pi tape - camera 75cm 15 wires 1mm raster
Tape with a length of 75 cm connecting the minicomputer Raspberry Pi with the dedicated camera. The connector has 15 veins, pitch is 1 mm.Tact Switch 12x12mm with cap - mushroom yellow - 5pcs
Button size 12x12 mm, cap height: 5.7 mm, cap diameter: 12 mm, cap color: yellow . Price for 5 pcs.Programmer USB AVR Pololu v2.1 - microUSB 3,3V/5V - Pololu 3172
Pololu programmer compatible with with the popular STK500. It can be used to program AVR microcontrollers via the microUSB cable. Version 2 is equipped with two connectors...
