- Reduced price
- Promotion
Soldering station hotair and tip-based 2in1 Zhaoxin 852DH - 75W
Index: LUT-09834
- Reduced price
- Promotion
- Reduced price
- Promotion
- Reduced price
- Promotion
Air quality gauge Benetech GM8803 PM2.5 and PM10 with display
Index: BNT-10775
- Reduced price
- Promotion
- Reduced price
- Promotion
- Reduced price
- Promotion
Grove modules - Strona 4
Loading...
Grove RS-485 module allows to connect Arduino to RS-485 bus. Easy to use plug and play device. The module features high stability and supports 500 kB/s error free...
Index: SEE-14130
Index: SEE-14130
Grove AHT20 - temperature and humidity sensor - I2C - - Seeedstudio 101990644
The Grove AHT20 is a new generation sensor, enabling even more accurate measurements. The AHT20 has a newly designed ASIC with an improved MEMS semiconductor moisture...
Index: SEE-16595
Index: SEE-16595
A small micro servo with a Grove connector that allows direct connection to a Base Shield plate. Powered from 4.8 V to 6 V, torque is 1.8 kg*cm and speed is 0.10 s/60°. The...
Index: SEE-15326
Index: SEE-15326
433 MHz RFM95 radio module of the long range (Long Range: LoRa). It allows for data transmission at the distance of up to 500 m using a piece of wire as an antenna. It a lso...
Index: SEE-09086
Index: SEE-09086
Grove - 10kΩ linear sliding potentiometer
Sliding linear potentiometer with a resistance of 10 ohms. Itas a 4-pin Grove connector. The kit includes a cable adapted to Seeedstudio Base Shield v2.0.
Index: SEE-04436
Index: SEE-04436
Grove - BME280 - humidity, temperature and pressure sensor 110kPa I2C 3-5V
The Grove module is equipped with a humidity, temperature and pressure sensor powered with the voltage of 3.3 V to 5 V with I2C and SPI interface. Measuring range: temperature:...
Index: SEE-11355
Index: SEE-11355
Grove - Grove-4pin - BLS connector - extension from M5Stack - 10pcs.
The module has a Grove type connector on one side and a 4-pin connector with a 2.54 mm pitch on the other side. It is used as an auxiliary element when some sensors of...
Index: MSS-19421
Index: MSS-19421
Totem Rack for Arduino, Raspberry and Grove series modules - TotemMaker TKM-GR1
The Totem Rack is a frame for holding electronic modules , which significantly facilitates their further prototyping . The elements are mounted at an angle of 45 degrees...
Index: TOT-21323
Index: TOT-21323
Grove AC-Voltage sensor - RMS AC voltage sensor - MCP6002 - Seeedstudio 101991032
The sensor is equipped with the MCP6002 system and is designed to measure the rms value of AC voltage . It has adjustable gain for various voltage inputs from 120 V to...
Index: SEE-22416
Index: SEE-22416
Grove - 12-bit Magnetic Rotary Position Sensor / Encoder (AS5600)
The module is equipped with AS5600 magnetic encoder with 12-bit resolution. It has greater accuracy, is non-contact and has no angle limitation, unlike a traditional...
Index: SEE-15546
Index: SEE-15546
Grove - LCD display 2x16 characters with backlight (Black on Yellow)
Monochrome 2 x 16 character LCD display with high brightness backlight from Grove. The module communicates with the control board via the two-row I2C bus. The screen is powered...
Index: SEE-14735
Index: SEE-14735
Grove - RGB LED v2.0 - module with RGB diode
Module with RGB diode from Grove. It a llows you to control RGB diode using the digital pins of the microcontroller, and simultaneous connection of even 1024 modules using...
Index: SEE-11299
Index: SEE-11299
Grove - module cover 1x1 blue - 4pcs.
Shield for the modules from Grove series in blue color with size of 25 x 25 x 13 mm. It is also compatible with Lego and Makeblock. It allows you to mount a small Grove module....
Index: SEE-13339
Index: SEE-13339
Grove ADS1115 - 4-channel 16-bit ADC for Raspberry Pi - Seeedstudio 103030279
Grove 4-channel 16-bit ADS1115 ADC is an analog-digital converter (ADC) in the form of shield for GPIO connectors of Raspberry Pi. It is 4-channel ADC based on the ADS1115...
Index: SEE-13814
Index: SEE-13814
Grove - rotary encoder with a button
Knob in a form of an encoder with a button that allows you to create a simple user interface. The module sends a digital signal to the SIGA and SIGB outputs, depending on the...
Index: SEE-11309
Index: SEE-11309
Grove Creator Kit - Gamma - set of 40 Grove modules to Arduino
Set consisting of 40 modules and cables with Grove interface. It has been designed for creators of all ages, regardless of their level of sophistication and experience with...
Index: SEE-15410
Index: SEE-15410
Grove - VOC and CO2 gas sensor SGP30 - semiconductor MOS - Seeedstudio 101020512
The SGP30 sensor module is used to detect volatile organic compounds (VOC) and carbon dioxide (CO2). It communicates through the I2C interface. On the board there is a...
Index: SEE-15542
Index: SEE-15542
The control module from a Grove series. It has a built-in tact-switch system and pull-down resistor. It communicates with the microcontroller through a digital signal.
Index: SEE-13344
Index: SEE-13344
Grove - set of 5 female-female 4-pin - 2mm / 40cm with latch
A set containing five 4-pin Grove cables with a clip, 40 cm long. The cables are used to connect the sensors to the Grove connector with the base cover.
Index: SEE-15574
Index: SEE-15574
Grove - laser dust sensor / air quality PM2.5 (HM3301) - 5V
Grove Laser PM2.5 Sensor (HM3301) is a new generation of the laser sensor of dust / air quality, which in real time, allows for monitoring of air quality. It is e quipped with...
Index: SEE-13812
Index: SEE-13812
Grove - ADC converter for HX711 load cell sensors - Seeedstudio 101020712
Arduino compatible 24-bit ADC converter module allows to read values from pressure sensors. It has built-in amplifier with optional 32 dB, 64 dB and 128 dB gain. On the board...
Index: SEE-15855
Index: SEE-15855
Grove - digital PIR motion sensor - Seeedstudio 101020793
PIR sensor for motion detection using IR diodes. It allows to generate low or high state at the output. It does not require Arduino library for proper operation. It detects...
Index: SEE-16909
Index: SEE-16909
Grove - GrovePi+ v3.0 Shield for RaspberryPi 4/3/2/B/B+/A+
Shield for Raspberry Pi is equipped with a w15 4-pin connectors for connecting sensors from the Grove minicomputer series. It cooperates with more than a hundred modules.
Index: SEE-04451
Index: SEE-04451
Grove - Sensor for measuring EMG muscle activity
Module from the Grove series that allows you to collect the bioelectric signal generated by the human muscles (EMG). The output is an analog signal that can be read using any...
Index: SEE-11308
Index: SEE-11308
See also
- Inductive sensors
- Hall effect sensors
- Led motion detectors
- Optical sensors
- Twilight sensors
- Resistance sensors
- Door sensors
- Piezoelectric sensors
- RPM sensors
- Oxygen sensors
- Tilt sensors
- Accelerometers
- Alarm sensors
- 9DoF IMU sensors
- Pressure sensors
- Air quality sensors
- Sound sensors
- Gesture sensors
- Gas sensors
- Limit switches
- Sensors of light and color
- Magnetic sensors
- Medical sensors
- Pressure sensors
- Sensors odbiciowe
- Distance sensors
- Inductive contactless sensors
- Weather sensors
- Liquid level sensors
- Current sensors
- Flow sensors
- Motion sensors
- Temperature sensors
- PT100 temperature probes
- Humidity sensors
- Fingerprint readers
- Encoders
- Photoresistors
- Phototransistors
- IR receivers
- Magnetometers
- Gyros
- Sensor sets
- Gravity modules