List of products by brand Onlywood

Onlywood is a Polish manufacturer of wooden products, which include, among others boxes, ornaments, chairs or toys. The manufacturer offers products made of raw and varnished wood. Onlywood's activities also include engraving, burning, laser cutting and upholstery services. Onlywood's product range available in the Botland store includes plywood boards that can be used in many ways.

How to properly laser cut plywood?

Onlywood plywood consists of thin layers of veneer that have been glued and pressed together. As the engineering process uses the grain crossing technique, it reduces expansion and cracking, making it a relatively stable wood product. In the case of laser plywood, the results depend on the quality. High-quality plywood has its grains turned every 45 degrees, which increases axial strength, while thinner, inferior quality plywood is only placed at right angles.

The two types of plywood that are suitable for laser cutting are laser birch and bamboo plywood. Like maple and cherry, birch is a dense but easy-to-use hardwood that is easily accessible. It is great for beginners looking to get started with laser cutting as it cuts smoothly and reliably. If you're in the mood for more adventures, bamboo plywood may be an option. It is a dense wood grain that gives a delicate, delicate appearance after engraving, which makes it an excellent candidate for the job.

CO2 laser parameters for plywood processing

CO2 lasers are best suited for plywood processing because they offer the possibility to vary the laser power and have many possibilities that make the process of laser processing in wood pleasant and easy. It is important to remember that the edges are scorched when the laser is applied to the wood. The resulting heat energy causes the material to evaporate, so having wood with a lower resin content reduces the burning effect - as is the case with Onlywood plywood. There are several other factors to consider to make the most of this experience. The laser power should be selected according to the thickness of the material. When engraving, you need to increase the size of the laser spot for a darker engraving effect. This will increase burnout, resulting in weaker detail. When using a laser cutter, it's best to start with a cut speed of, say, around 5% and gradually adjust until you get the quality you want. If we start with a piece of plywood approximately 3mm thick, or approximately 1/10 ”thick, we will be able to judge what needs to be done to achieve good results with a piece of plywood approximately 6mm thick.

Setting the focal length for laser processing in plywood

For better detail accuracy it will be necessary to set a shorter focal length in combination with the appropriate parameters. It might be difficult. While a shorter focal length leads to an improvement, the proper thickness of the plywood requires a longer focal length for optimal results. For plywood it is best to try a lens with a focal length of 1.5 "or 2". Along with adjusting the cutting and engraving parameters to the selected type of wood, you should pay attention to the appropriate optics.

Personal protective equipment and accessories helpful in processing plywood

Before the first run, prepare yourself and your material. This means that you should wear personal protective equipment, such as a dust mask and safety glasses. With each substance that is fired, there is an uplift of dust and particles. This is especially true for plywood, and this kind of contamination can enter the laser machine and cause breakdowns. One way to counter this is by sticking application tape - the type of tape used for vinyl graphics - onto the wood. It is safe to use and not only will minimize dust but can also reduce material burning. After finishing the treatment, remove the protective tape. The test must be performed on a separate piece before the first official firing attempt to ensure that all parameters have been selected correctly.

Cleaning the plywood after processing

You can do everything possible to reduce dust, but you will never be able to eliminate it. If plywood dust is left in the product, it may clog the laser light and damage the optics. Remember that wood dust contains resin and oil that will stick to your gear. Clean your laser regularly to keep it in top condition for your engraving and cutting projects. Wood is an excellent material for engraving souvenirs and gifts. It has a personal touch which makes it even more special.