Description
PHAT shield for Raspberry Pi, it has signed GPIO pins to facilitate the recognition of individual pins, three programmable buttons, status LEDs for GPIO ports and active buzzer.
Maker PHAT for Raspberry Pi
Shield has dimensions of the Raspberry Pi Zero but is also compatible with Raspberry Pi 3B+ / 3B. For mounting the shield on the Raspberry Pi 3B+ / 3B, use extended pins (included).
Mounting with the Raspberry Pi Zero
For installation withRaspberry Pi Zero / Zero W, you must solder the goldpin connectors to minicomputer, beforehand.
Installation with Raspberry Pi 3B+ / 3B
To install the shield onthe Raspberry Pi 3B+ / 3B, you must first mount the extended goldpin strip.
Key features
- The size of the Raspberry Pi Zero
- Compatible with Raspberry Pi 3B+ / 3B / 3A+ / 4B and Raspberry Pi Zero / W / WH
- Standard GPIO pins of the Raspberry Pi
- A LED array for the selected GPIO pins (GPIO 17, 18 ,27, 22, 25, 12, 13, 19)
- 3 programmable buttons (GPIO 21, 19 and 20 must be configured as a pulled up input)
- Active buzer (GPIO 26)
- Signed GPIO, it contains SPI, UART, I2C, 5V, 3.3 V and GND
- MicroUSB for power supply of 5 V and UART communication
- Serial USB interface supported by the chip CH340
- Input voltage of 5 V
- Purple PCB
Set includes
- Shield Maker pHAT
- 1x strip goldpin 2x20 - pin
Useful links |
