Product description: 2in1 hotair and tip soldering station Yato YT-82458 - 750 W
Yato YT-82458 2-in-1 soldering station equipped with a 75W tip and a hot air flask. The 908D tip stock works with 900M Tx tips , the temperature range is from 200 ° C to 480 ° C, the temperature accuracy is +/- 1 ° C. The hotair air flow is 120 l / min , the temperature range is from 100 ° C to 480 ° C , the temperature accuracy is +/- 2 ° C. The hotair stock is equipped with a brushless fan that ensures quiet operation of the device. The station is also equipped with a double LED display, temperature control and numerous functions facilitating proper soldering connections. The total power of the station is 750 W.
Kit contents
- 2in1 hotair and tip soldering station Yato YT-82458 - 750 W
- Round nozzle 4.4 mm
- Round nozzle 8 mm
- Round nozzle 10 mm
- Square nozzle 12 mm
- 908D stock with a stand and a sponge
2in1 hotair and tip soldering station Yato YT-82458 - 750 W. 
908D tip stock.Yato YT-82458 soldering station specification
- Series: GRE
- Type: ESD-safe
- Supply voltage: 220 V to 240 V AC / 50 Hz
- Power: 750 W
- Power switch
- Fuse
- Electrical insulation class: II
- Functions: temperature stabilization, automatic cooling and hibernation, device hibernation, sensor failure detection, automatic shutdown
- Display: blue LED
- Tip soldering iron:
- power: 75 W
- temperature range: from 200 ° C to 480 ° C
- temperature accuracy: +/- 1 ° C
- device hibernation: 10 min
- stock: 908D
- heater operating voltage: 24 V
- tip type: 900 M.
- ceramic heater
- heater outer diameter: 3.85 mm
- cable length: 1 m
- flask weight: approx. 100 g
- Hotair soldering iron:
- power: 750 W
- temperature range: from 100 ° C to 480 ° C
- temperature accuracy: +/- 2 ° C
- air flow: max. 120 l / min
- smooth regulation of air flow
- brushless fan ensures quiet operation
- automatic cooling and hibernation of the device after putting down the hotair handle
- three round nozzles with diameters: 4.4 mm, 8 mm, 10 mm
- square hotair nozzle, side: 12 mm
- diameter of the nozzle holder: 21 mm
- ceramic heater
- cable length: 1 m
- handle weight: approx. 200 g
First run
- After delivery of the equipment, it should not be started immediately.
- Equipment should remain at room temperature for approximately 12 hours before being put into operation.
- Any reports of defects caused by premature start-up of the equipment will be rejected.
Attention
Heating elements (heaters) and tips are not covered by the guarantee or warranty and their replacement is payable.
We also offer soldering accessories:
