SENSORS - Strona 29
Grove - infrared thermometer OTP-538U IR
Module from the Grove series, based on a sensor OTP-538U which, to measure the temperature, is using the analysis of infrared radiation in the range from -10 °C to 100 °C. It...DFRobot Gravity - MLX90614-DCI IR thermometer - non-contact
Non-contact temperature IR sensor MLX90614-DCI. It is used for measurement of IR radiation and does not require direct touch. It communicates through an I2C interface.MS8607 - Pressure Humidity Temperature PHT Sensor I2C STEMMA QT/Qwiic - Adafruit 4716
Adafruit PHT pressure, humidity and temperature sensor. Compatible with Arduino, Metro, Feather and Raspberry Pi. Powered from 3.3 V to 5 V with I2C interface and STEMMA...VL53L3CX time-of-flight - distance and ambient light sensor I2C - 500cm - Pololu 3416
Digital sensor for time-of-flight distance and ambient light measurement. The measurement range is from 1 cm to 500 cm with a resolution of 1 mm . It uses I2C (TWi)...Gravity - connection cable set - male plug PH2.0 - 30cm - 10pcs. - DFRobot FIT0897
A set of connecting cables equipped with a connector compliant with the Gravity standard and a 3-pin PH2.0 male goldpin connector. The cables were manufactured by DFRobot, they...QR code scanner - STM32F030 - Unit extension module - M5Stack U173
QR code scanner module in the form of a Unit extension from M5Stack, enabling reading of one-dimensional and two-dimensional codes . Equipped with a CMOS capture sensor with...SparkFun Qwiic Thermocouple Amplifier - MCP9600 - with screw connector - SparkFun SEN-16295
High accuracy thermocouple amplifier module that enables the built-in MCP9600 chip. It uses the I2C communication interface via the Qwiic connector. It enables temperature...VL53L1X time-of-flight - distance sensor - 4m - Waveshare 14929
The VL53L1X distance sensor measures up to 4 m at a speed of up to 50 Hz . The system uses Time-of-Flight technology and uses the I2C interface for communication. The...Gravity - RS485 to UART signal converter - DFRobot DFR0845
Module converting transmission signal from RS485 protocol to UART serial interface. It has a built-in TDH541S485H chip. It is compatible with most controllers, including...VCNL4040 - Proximity Sensor Breakout - 20cm (Qwiic) - SparkFun SEN-15177
A digital sensor that combines the ability to measure proximity IR and measure the intensity of ambient light. The module allows to detect obstacles in the range of 0 to 20 cm....Dust / air quality sensor - PM2,5 PMS1003 - 5V UART
Laser dust sensor that allows you to monitor air purity in real time. It measures PM2.5. The system is powered by 5 V, while the interface works with 3.3 V and communicates...VL53L1X time-of-flight - distance sensor - STEMMA QT / Qwiic I2C - Adafruit 3967
Adafruit time-of-flight distance sensor module VL53L1X . The VL53L1X sensor allows distance measurements in the range of 30 mm to 4000 mm with the precision of LIDAR...ADT7410 - High Accuracy I2C Temperature Sensor Breakout Board - Adafruit 4089
Adafruit temperature sensor with high accuracy with digital thermometer ADT7410 in the range of -40°C to +105°C equipped with interface I 2 C (TWI). The supply voltage ranges...Gravity - gesture and touch sensor - UART- DFRobot SEN0285
A sensor module that combines gesture and touch recognition functions. It allows the detection of gestures from a distance of 0 to 30 cm, this distance can be adjusted in the...VL53L4CX time-of-flight - distance sensor - STEMMA QT / Qwiic I2C - Adafruit 5425
The Adafruit module is equipped with the VL53L4CX time-of-flight distance sensor, which allows you to measure distances in the range from 1 mm to 6000 mm with the precision...Fermion - CH4 methane sensor - MEMS - 1-10000ppm - DFRobot SEN0565
A compact sensor manufactured by DFRobot that allows you to measure the concentration of methane CH4. The detection range is from 1 ppm to 10,000 ppm . Methane has a...Gravity - set of digital connection wires - male plug PH2.0 - 30cm - 10pcs. - DFRobot FIT0896
A set of connecting cables with a length of 30 cm equipped with two connectors - one compatible with the Gravity standard and one 3-pin PH2.0 male goldpin connector. The...9DoF IMU Breakout - ISM330DHCX, MMC5983MA - Qwiic - SparkFun SEN-19895
SparkFun Qwiic 9DoF IMU Breakout sensor combines a high-performance digital ISM330DHCX accelerometer, a gyroscope and a highly sensitive three-axis magnetometer MMC5983MA ....LSM6DSO - 3-axis accelerometer and I2C/I3C/SPI gyroscope - Pololu 2798
The LSMDDSO sensor from Pololu is the successor to the older LSM6DS33 module and is a combination of a 3-axis accelerometer and a gyroscope. It allows you to measure 6...BitMaker V2 - expansion board for BBC micro:bit - Seeedstudio 114992653
The BitMaker V2 expansion board for BBC micro: bit is equipped with Grove connectors that allow for trouble-free connection of modules with the same interface. On the board...Micro 3-axis magnetometer - MMC5983MA - Qwiic - SparkFun SEN-19921
3-axis magnetometer in miniature version, equipped with the MMC5983MA system by MEMSIC . It is characterized by high sensitivity , allowing the accuracy of the course on...Sense HAT (C) - multifunctional environmental sensor - overlay for Raspberry Pi - Waveshare 23229
Sense HAT (C) is a multifunctional module equipped with a number of environmental sensors. It has the form of a HAT overlay and is compatible with the Raspberry Pi. It has...Grove - ITR9909 reflectance sensor v1.2
Module from the Grove series is based on a reflective sensor ITR9909. It consists of LED emitting the infrared light and phototransistor of high sensitivity. It is supplied...
