









The original module from the Arduino Uno with the AVR microcontroller ATmega328 in an interchangeable housing. It has 32 KB Flash memory, 2 KB RAM, 14 digital I/o of which 6 can be used as PWM channels, 6 analog inputs and popular communication interfaces.
Arduino Uno is the main and, at the same time, the most popular edition of the entire series. The Board contains an ATmega328 microcontroller, equipped with 14 digital I/o of which 6 can be used as PWM outputs (e.g. for motor control), and 6 analog inputs. The system works with the signal ticking with the frequency of 16 MHz and has 32 KB Flash memory and 2 KB RAM SRAM.
The subject of the sale is the original product of Arduino Uno, Botland is the official distributor of this company.
Below are a few features that distinguish modules Arduino Uno compared to other programmable tiles.
Name | Description |
---|---|
Installed bootloader |
Thanks to installed bootloader, to programme the device, the appropriate USB cable and software from manufacturer's website is enough . |
Arduino Shield |
The distribution of connectors allows the installation of special plates, so-called Arduino Shield. |
Digital outputs |
14 digital inputs/outputs allows, in particular, control of LEDs, relays and reading the buttons' states. |
Efficiency of current |
The maximum power load for a single output is 40 mA. |
PWM Outputs |
6 PWM outputs allow e. g. motor control and brightness control of the LEDs. |
Analog inputs |
6 inputs of built-in analog-digital converter box with a resolution of 10-bit support, in particular, sensors with analog output. |
Serial Communication |
The device supports popular network interfaces, including UART, I2C and SPI. |
Special functions | Some of the pins have special functions and their brief description is available in our guide. |
Built-in memory |
Atmega328 system with a clock signal with a frequency of 16 MHz, has 32K Flash memory, 1 KB EEPROM and 2 KB of RAM SRAM. |
Power DC connector |
To power the Arduino, you can use any power source with a voltage from 7 V to 12 V with DC connector 5.5 x 2.1 mm. |
Power USB port |
The tile can be powered from a computer via USB cable , bearing in mind that the maximum power load for the USB port is 500 mA. Arduino has a system that protects the socket from short-circuit and the flow of too large current. |
ICSP Connector |
The module has ICSP outputs for connecting an external AVR programmer. |
IOREF Pin |
The IOREF Pin provides direct access to the volatge with which I/O outputs work. |
Built-in led |
The connected led on pine 13 allows debugging of simple programs. |
Output 3.3 V |
Built-in voltage regulator provides power to external devices with the voltage of 3.3 V with current consumption of 50 mA. |
Microcontroller in THT |
Thanks to the use of THT case, in case of damaging the main microcontroller Atmega328P you can easily replace it. |
First run To help you get started with the module, we have prepared a tutorial that concerns the installation and first run of the Arduino environment. |
The distribution of elements on the Arduino Uno.
ThingSpeak platform for Arduino and Raspberry Pi IoT.
Useful links |
Voltage to | 7.0 V |
Voltage from | 12.0 V |
Voltage output from | 5.0 V |
Output voltage to | 5.0 V |
Nominal output voltage | 5.0 V |
UC - Microcontroller | ATmega328 |
UC - Core | 8-bit AVR |
UC - EEPROM | 1 kB |
UC - Flash | 32 kB |
UC - RAM | 2 kB |
UC - core | 1. Single Core |
UC - Digital pins | 14 |
UC - analog in | 6 |
UC - freq | 16 MHz |
UC - A/C | 10-bit |
UC - PWM | 6 |
UC - USB | USB B |
UC - I2C | yes |
UC - UART | yes |
UC - SPI interface | yes |
Posting the payment for the order on our account on a business day up to 10 AM means sending the goods on the same day!
The time of payment depends on the ELIXIR's hours session of the sender's bank and the recipient of the transfer. It may take up to 2-4 working days.
Only for prepaid orders shipped to Poland.
Austria, Belgium, Croatia, The Czech Republic, Denmark, Germany, Netherlands, Slovakia
Bulgaria, Estonia, France, Hungary, Italy, Latvia, Lithuania, Luxembourg, Portugal, Romania, Slovenia
Finland, Greece, Ireland, Sweden, Cyprus, Malta, Spain
No customer reviews for the moment.
Customers who bought this product also bought:
Arduino MKR1000 module ABX00011 - Wi-Fi ATSAMW25 - with connectors
The module based on ATSAMW25 Atmel SoC system with wi-fi, designed for IoT projects. Equipped with Cortex-M0. Has 256 KB Flash memory, 32 KB SRAM, 8 digital inputs/outputs, 12...Arduino MKR Zero module ABX00012 - SAMD21-with connectors
Module with chip Atmel SAMD21 Cortex-M0+, allowing you to study modules for 32-bit. Has 256 KB Flash memory, 32 KB SRAM, 22 digital inputs/outputs, 12 channels PWM) and 7...Arduino GSM MD 1400-B - module ABX00018 with connectors
The module based on the layout of the Atmel SAMD21 SoC with GSM module SARAU201 designed for IoT projects. Equipped With A Cortex-M0+. Has 256 KB Flash memory, 32 KB SRAM, 8...Arduino MKR FOX 1200 ABX00014 - module of network SigFox
Module based on chips Atmel SAMD21 and ATA8520, allowing network SigFox 868MHz . Equipped with a Cortex-M0+. It has 256 kB of Flash memory, 32 kB SRAM, 8 digital pins,...Arduino MKR1000 module ABX00004 - Wi-Fi ATSAMW25 - without connectors
The module based on ATSAMW25 Atmel SoC system with wi-fi, designed for IoT projects. Equipped With Cortex-M0. Has 256 KB Flash memory, 32 KB SRAM, 8 digital inputs/outputs, 12...Arduino MKR1010 module ABX00023 - Wi-Fi ATSAMW25 + ESP32 - with connectors
The module based on the ATSAMW25 Atmel SoC system with wi-fi ESP32 U-Blox designed for IoT projects. Equipped With Cortex-M0. Has 256 KB Flash memory, 32 KB SRAM, 8 digital...Arduino MCR Vidor4000 ABX00022 - module with FPGA Cyclone 10
The module based on the system Atmel SAMD21, designed for IoT projects. Equipped with a Cortex-M0+. It has 2 MB of Flash memory, 8 MB SRAM. In addition, the system is...Arduino MKR WAN 1300 LoRaWAN ABX00017 module - SAMD21 - with headers
The module is equipped with a 32-bit processor Atmel ARM Cortex-M0+, 256KB Flash memory and 32KB SRAM. It combines the capabilities of tile MKR Zero and connectivity LoRa. The...Filament Velleman PLA 1.75mm 0,75kg - white
Filament made of PLA used as a cartridge for 3D printers and printing pens. The diameter is 1.75 mm. The kit contains 750 g filament in white color with length of approx. 250m.Filament Spectrum PLA 1.75mm 1kg - Deep Black
Filament made of PLA used as a cartridge for 3D-printers and printing pens. The diameter of 1.75 mm. The set includes 1kg of filament in color Deep Black with length of 330.m.Filament Spectrum PLA 1.75mm 1kg - Polar White
Filament made of PLA used as a cartridge for 3D printers and printing pens. The diameter of 1.75 mm. The set includes 1kg of filament in color Polar White with length of 330 m.Filament Spectrum PLA 1.75mm 1kg - Arctic White
Filament made of PLA used as a cartridge for 3D printers and printing pens. The diameter of 1.75 mm. The set includes 1kg of filament in color Arctic White with length of 330...Products from the same category
Arduino Pro Mini 328 module - 5V/16MHz - SparkFun DEV-11113
The module based on the Arduino Uno is characterized by small size and low profile. There is an Atmega328 microcontroller with 32 KB Flash memory, 2 KB RAM, 14 digital I/o, 6...Arduino Leonardo - module A000057
Popular module with AVR microcontroller Atmega32U4. Has 32 KB Flash memory, 2.5 KB RAM, 20 digital inputs/outputs, of which 7 can be used as PWM channels and 12 as analog...Arduino Micro - module A000053
Module based on the Arduino Leonardo with Atmega32U4 AVR microcontroller, is characterized by small size. Has 32 KB Flash memory, 2.5 KB RAM, 20 digital inputs/outputs, of...Arduino StarterKit K000007 - the official starter set with Arduino Uno A000066
Starter set introducting to the world of Arduino programming. Allows the construction of more than a dozen projects using Arduino and i. a.: temperature sensor, photoresistor,...Trinket - Mini Microcontroller module - 5V - Adafruit 1501
Miniature module with an AVR Attiny85 microcontroller and is equipped with 8 KB of Flash memory, 5 digital pins, analog input and 2 PWM channels. On board is microUSB...Arduino Pro Mini 328 module - 3.3 V/8 MHz - SparkFun DEV-11114
The module based on the Arduino Uno, is characterized by small size and low profile. It has an Atmega328 microcontroller with 32 KB Flash memory, 2 KB RAM, 14 digital I/o, 6 of...Arduino Due ARM Cortex - module A000062
The popular run set based on the Atmel AT91SAM3X8E. Thanks to the Arduino Due, the user can create layouts using a system with a 32-bit core ARM Cortex, based on libraries for...DFRduino Uno v3 - compatible with Arduino
DFRobot module fully compatible with Arduino Uno R3. It has 14 digital inputs/outputs, 6 PWM channels, 6 analog inputs and popular communication interfaces. Colored connectors...Makey Makey - version Classic - by JoyLabz - SparkFun KIT-14478
This kit consists of USB board and cables, allows you to create keyboard of any items, such as chagning the stairs into piano or making the gamepad from the fruits. The device...Cytron Maker Uno - compatible with Arduino
The Cytron module, compatible with Arduino Uno R3. It has 14 digital input/outputs, 6 PWM channels, 6 analog inputs, as well as popular communication interfaces. In addition,...Arduino Mega 2560 Rev3 - module A000067
Popular module with microcontroller AVR ATmega2560 . It has 256 KB Flash memory, 8 KB RAM, 54 digital inputs/outputs, of which 15 can be used as PWM channels, 16 analog...