Product description: PiCowbell terminal - shield for Raspberry Pico / Pico W - screw connectors - reset button - STEMMA QT - Adafruit 5907
The Adafruit PiCowbell Terminal is a practical extension designed for projects based on the Raspberry Pi Pico and Pico W . With four 10-pin screw connectors with a pitch of 2.54 mm , it allows you to connect wires from 18 AWG to 26 AWG to each GPIO pin. It also has a reset button, a JST SH connector for I2C, and additional solder pads for connecting to other devices. Each pin is mapped 1:1 to its corresponding pin on the board, providing multiple connections to ground (GND). The module comes with pre-soldered connectors, allowing you to use it right away without having to solder. Additionally, the board has a reset button and a JST SH connector for the I2C / STEMMA QT / Qwiic interface, allowing you to easily connect I2C modules or use it for standard GPIO wiring. There are also lead-out holes next to the JST SH connector for additional I2C connections or assigning another I2C port.
PiCowbell terminal - shield for Raspberry Pico / Pico W - screw connectors - reset button - STEMMA QT - Adafruit 5907.
The Adafruit PiCowbell Terminal is a practical extension designed for projects based on the Raspberry Pi Pico and Pico W.Special Features
- Screw connectors for each Pico or Pico W pin - 40 pins and 40 connectors in total
- Pre-soldered connectors - allow you to connect your Pico or Pico W immediately without the need for soldering
- Reset button - located at the end of the board for easy access
- JST SH connector - supporting I2C / STEMMA QT / Qwiic, allowing easy integration with I2C modules
- Additional pinout holes - next to the JST SH connector, allow for I2C connections or assigning another port
- Prototype area - 12 rows of 4 connections, organized in the central part of the board, allow for quick building of simple electronic circuits without using a traditional breadboard
- Multiple ground connections - marked with white print for easy identification
- A row of connected holes designed for 3.3V power supply - for easy connection
Technical specifications PiCowbell Terminal
- Compatibility: Raspberry Pi Pico, Pico W
- Screw connectors: 4 x 10-pin, pitch 2.54 mm
- Supported wire sizes: 18 to 26 AWG
- Power supply: long strip of holes for 3.3 V voltage - row of connected holes
- I2C connector: JST SH (STEMMA QT / Qwiic)
- Power supply: long strip of holes for 3.3 V
- Soldering pads: gold plated, for easy soldering
- Dimensions: 52.1mm x 43.1mm x 10.6mm
With four 10-pin screw connectors with a pitch of 2.54 mm, it allows you to connect wires with a cross-section of 18 AWG to 26 AWG to each GPIO pin. 
