Product description: Air quality sensor ENS160 MOX - STEMMA QT / Qwiic - Adafruit 5606
Adafruit module based on the ENS160 MOX system, which is used to monitor indoor air purity . It processes IAQ (Indoor Air Quality) data such as TVOC , eCO2 , AQI - it is a combination of TrueVOC and MOX technologies that allow you to obtain interference-free measurements. Accurate data reading is possible thanks to the use of high-quality systems. The eCO2 measurement range is from 400 ppm to 65,000 ppm and the TVOC range is from 0 ppb to 65,000 ppb . The sensor is supplied with a voltage in the range from 3 V to 5 V.
Air quality sensor ENS160 MOX - STEMMA QT / Qwiic - Adafruit 5606.
The air quality sensor allows you to monitor the cleanliness of the rooms.
Special features of the module
- Allows the detection of reducing gases - volatile organic compounds (VOCs) and oxidizing gases
- Supports up to 4 independent MOX gas sensors
- Includes integrated, pre-calibrated algorithms for sensor fusion and automatic baseline correction
- The warm-up time is less than 3 minutes, which allows for quick data reading
- Reading environmental data: TVOC, eCO2, AQI
Also check the manufacturer 's user guide !
Sensor connection diagram and pin description
The diagram shows the connection of the module to the Raspberry Pi board. The sensor uses the I2C or SPI interface for communication. The pins of the module are solder pads to which the included goldpin strip should be soldered. The manufacturer also placed STEMMA QT / Qwiic connectors on the board, which can be used as an alternative connection method.
- VIN - power supply from 3 V to 5 V
- 3Vo - 3.3V power supply
- GND - system ground
- SCK / SCL - clock line of the SPI / I2C bus
- SDI / SDA - data line of the SPI / I2C bus
- CS - pin chip select SPI / I2C selection
Diagram of connecting the ENS160 air quality sensor to the Raspberry Pi.
Kit contents.
Module technical specification
- Type: air quality sensor / air purity sensor
- Built-in chip: ENS160
- Supply voltage: 3.3 V to 5.5 V
- Communication interface: I2C / SPI bus
- I2C address: 0x53
- eCO2 measurement range: 400 ppm to 65,000 ppm
- TVOC measurement range: 0 ppb to 65000 ppb
- Module dimensions: 25.4 x 17.6 x 4.5 mm
Kit contents
- Air quality sensor ENS160 MOX - STEMMA QT / Qwiic - 1 piece
- Goldpin strip 1x8 pin - raster 2.54 mm - 1 piece
Useful links |
