Product description: Fermion - LCD IPS TFT 1.8 "128x160 px SPI display - DFRobot DFR0928
The Fermion LCD TFT IPS display is based on the ST7735S driver, its diagonal is 1.8 " , and the resolution is 128 x 160 px . It uses a 4-pin SPI interface for communication. The built-in microSD memory card slot allows easy reading of color bitmaps from the memory card In order to connect the display with the main module, two methods can be used: standard connection via SPI or GDI (General Display Interface). The module can be easily connected to FireBeetle using the FPC tape. The board works with a voltage from 3.3 V to 5 V and draws up to 0.11 W of power.
Fermion LCD IPS TFT 1.8 "series display.
The module is equipped with a microSD card slot.Main features of the Fermion screen
- 128 x 160 px resolution
- 4-wire SPI communication
- Integrated microSD card slot
Screen application
- Display of measurement data from sensors, alarm
- Arduino temperature monitoring
- Fan controller
The manufacturer provides a user guide along with sample Arduino code.
Fermion screen outputs
The Fermion display module for communication uses a 4-wire SPI interface. Works with a voltage from 3.3 V to 5 V. Can be connected to the FireBeetle module using the FPC tape.
- VCC - power supply from 3.3 V to 5 V
- GND - the ground of the system
- SCLK - clock line of the SPI bus
- MOSI - receiving SPI data
- MISO - sending SPI data
- CS - layout selection
- RES - reset
- DC - data / commands
- BLK - backlight
- SDCS - microSD card layout selection
The pins of the module.
Fermion - LCD IPS TFT 1.8 '' 128x160px SPI display - DFRobot DFR0928.
IPS TFT LCD Display Specification
- Working voltage: from 3.3 V to 5 V
- TFT viewing angle: 120 °
- Number of pixels: 128 columns x 160 rows
- Communication: SPI
- Interface type: GDI, pin connector
- Driver chip: ST7735S
- Power consumption: 0.11 W
- MicroSD card slot
- Operating temperature range: -10 ° C to 60 ° C
- Display area size: 26 x 35 mm
- Module dimensions: 34 x 55 mm
- Mounting hole spacing: 29 mm, 50 mm
- Mounting holes diameter: 2 mm
Kit contents
- 1x Fermion - LCD IPS TFT 1.8 '' 128x160px SPI display - DFRobot DFR0928
- 1x GDI cable
- 1x 10-pin connector
