- EOL
|
Attention! The product has been discontinued. Check other products in category. |
Description
Holding electromagnet is powered with voltage of 12 V. It keeps the weight of 320 kg by standard earth acceleration of 9.8 m/s2. The dimensions of the electromagnet are 250 x 49 x 26 mm. Included is a set of mounting screws.
The device can be used as an actuator controlled by any microcontroller, e.g. an Arduino. Please note that an electromagnet consumes too much power to connect it directly to the pins of the microcontroller. For this purpose, you can use relays, optical isolator or transistor amplifier.
|
Attention! The manufacturer recommends maintaining a good heat dissipation from the housing, because with the temperature rise of the coil, the force that holds, decreases. |
Specification
- Supply voltage: 12 V
- Load: 320 kgf (keeps the weight of 320 kg for the gravitational acceleration 9.8 m/S2)
- The wires with insulation removed at the ends with the length of about 12 cm.
- Set has the installation screws
- The LED indicating the power
- Electromagnet dimensions:250 x 49 x 26 mm
- Dimensions of metal board: 180 x 39 x 11 mm
Included
- Electromagnet
- Tile metal board
- Set of installation screws
- Hex key
