Product description: FEP foil for 3D printer Anycubic Photon Mono X - 2pcs
FEP foil for Anycubic Photon Mono X printer. It is a consumable element, installed as the bottom of the vat with resin. It allows the light coming from the UV matrix to pass through with a wavelength of 405 nm, which is necessary for curing the printing material. The items for sale are two FEP films.
In the offer of our store there is also a 3D printer Anycubic Photon Mono X.
FEP foilfor 3D printer Anycubic Photon Mono X - 2pcs.
Light permeable foil for Photon Mono X.
Steps for the replacement of the foil
- Remove 14 screws to detach the steel frame from the resin vat
- In the next step, remove 22 screws to lift the steel frame and remove the old film
- Then place the new FEP film between the two steel frames and screw the 22 screws back in
- The final step is to reinstall the steel frame in the resin vat and make sure that the FEP film is clean and properly tensioned
- The FEP foil should not be cleaned with sharp tools. This can scratch the surface.
- The FEP film is a consumable part of the instrument. The FEP foil is a consumable part of the device. It should be replaced in case of deformation, physical damage or excessive adhesion of the resin.
Specification of FEP foil for Anycubic Photon Mono X
- Consumable part dedicated to resin 3D printer Anycubic Photon Mono X.
- The material of the film shows resistance to high temperatures and chemicals. It has a non-stick surface.
- Light transmission: 95%
- Thickness: 0,15 mm
- Dimensions: 260 x 175 mm
