Description
The stand is designed to fit any gas sensor from MQ sensor. Thanks to it, the connection of the sensor is reduced to only three (instead of six) pins (VCC, GND, VOUT).
Stand has goldpin pins which allow for the connection of the sensor with a commissioning set (e.g.Arduino) using female-male wires.
Connection
VCC- 5V power supply
GND- ground
VOUT- output signal
On board is also a place for a resistor that regulates the sensitivity of the sensor (in the documentation called RL). The resistor can be connected in two ways: horizontally and vertically.
The gas sensors are not polarized and therefore can be installed in any order, at each side of the board (four options available).
Useful links |
